Expectation Setting Document for Fiery X2 V1.01Digital Front End for 5765, 5790 DocuColor 5750/ 5799Terms and product names used in this document may be trademarks or registered trademarks of their respective companies and are hereby acknowledged.Post Launch Version 26 May 1999Page 2 of 7 X2_Majestik_ced.docNetwork SpecificationsProtocol Stack PrintingServicesSupported Frame Types PlatformNovell IPX / SPX PServer Ethernet 802.2Ethernet 802.3Ethernet_IIEthernet SNAPToken Ring 802.2 (option)Token Ring SNAP (option)Windows NTWindows 95Windows 3.1TCP / IP LPD Ethernet_IIToken Ring SNAP (option)Windows NTWindows 95Solaris 2.4SunOS 4.1.xTCP / IP SMB Ethernet_IIToken Ring SNAP (option)Windows NTWindows 95AppleTalk PAP Ethernet SNAP(EtherTalk Phase 2 only)Windows NT 4.0MacintoshThe customer is responsible for supplying one network drop to enable the install.PrintingSTARR Compression• The Compression efficiency is dependent on file type and complexity. Artifacts may be possible whencompression is selected depending on the file complexity.• STARR Compression must be selected to support the advanced features in Fiery Options; i.e., collation, reverseorder, etc.Print Speed / System Performance• The maximum print speed for the X2 system is limited by the print speed of the 5765, 5790 and DocuColor 5750/5799.• The 5765, 5790 and DocuColor 5750/ 5799 are document printers; therefore the print engine will not cycle up untilthe entire job is ready. This will impact First Copy Out Time (FCOT) when STARR Compression is in use. Thecopier may cycle down between each job depending on job complexity.• Overall system performance (‘Click to Clunk’ time) is primarily dependent upon the software applications andnetwork environment being used. Rasterizing (RIP-ing) is only a small fraction of Click to Clunk time.• Printing with custom software applications may produce unexpected or unknown results.