Xantech XtraLink IP Quick Start Manual

Also see for XTRALINK IP: User guide

Contents

quick start guide

Xantech XtraLink IP Quick Start Manual Manual pdf 3 page image

APPLICATION NOTES: Adding Serial Ports to CRMWIC or WIC1200For use with CRMWIC as in the following Application Drawing, please proceed as follows:CRMWICNetwork HubCSPLCD64GKITSPLCDCB100SPLCDPS1PowerCABLE RECEIVERIPRS232RS422232IPRS232IPRS232Serial Port Configuration:1. Login as stated above.2. Click on Serial Port Settings located in the left pane of the setup page3. Enter the desired Baud Rate, Data Size, Parity, Flow Control and Signal Level to be used. This shouldmatch the unit being connected to.4. For use with the CRMWIC Web Intelligent Controllera) Select Telnet Clientb) Enter in the Remote Session IP Address (This will be the address of the CRMWIC you will be talkingto).Serial Port Configuration:5. Click on IP Settings located in the left pane of the setup page6. Enter the Static IP Address, Subnet Mask and Default Gateway for the XTRALINK IP unit7. Enter a HostName if required.Note: if using multiple IPRS232 XTRALINK IP’s make sure each unit has a unique IP address and Host Name.8. Click Apply Changes to save current settings.Note: PC will need to change to the same Subnet Mask and Default Gateway to re-enter the Setup Page.

/ 4

Related manuals for Xantech XTRALINK IP