Wanner Engineering Hydra-Cell MT8 Installation Operation & Maintenance

Wanner Engineering Hydra-Cell MT8 Installation Operation & Maintenance Manual pdf 2 page image

2190-999 Rev GMT8 OperationMT8 ContentsComponent IdentificationSteady State Accuracy ±1%Linearity ±3%Repeatability ±3%Maximum Discharge PressureMetallic Heads: 3500 psi (241 bar)Non-Metallic Heads: 350 psi (24 bar)Maximum Inlet PressureMetallic Heads: 500 psi (34 bar)Non-Metallic Heads: 300 psi (21 bar)Maximum Temperatures*Metallic Heads: 250°F (121°C)Non-Metallic Heads: 140°F (60°C)* Consult factory for correct component selection fortemperatures from 160°F (71°C) to 250°F (121°C).Inlet Port 1/4 inch NPT or BSPTDischarge Port 1/4 inch NPT or BSPTMaximum Solids 200 micronsSuction Lift Capacity 20 feet (6.1 meters)Shaft Rotation Bi-directionalOil Capacity 1-3/4 US quarts (1.7 liters)Weight (less motor)Metallic Heads: 100 lbs (45.4 kg)Non-Metallic Heads: 75 lbs (34 kg)Flow Rate 0.06 - 8.0 GPHBolt Torque See Pages 11,12,14,15,17,18Hydra-Cell Metering Solutions Pumps are hydraulicallyactuated, hydraulically balanced diaphragm metering pumpsthat exceed API 675 performance standards of ±1% steady stateaccuracy, ±3% linearity and ±3% repeatability.Due to their multiple diaphragm design, the MT Seriesmetering pumps provide virtually “pulse-free” linear flow. Unlikeconventional single diaphragm metering pumps, this linear flowreduces the need for pulsation dampeners and increases thereliability, performance, and safety of the metering pump system.Pump operation and plunger activation are accomplishedthrough a crankshaft.MT Series pumps offer either mechanical flow adjustment orflow adjustment through a variable-frequency drive (VFD).Pump pressure relief valve (54) is factory set to protect thepump from over pressurization. It is NOT to be used as a systempressure relief or regulator. Tampering with the relief valve willvoid manufacturer’s warranty.Maximum flow rate listed on page 3 of IOM should not beexceeded. API flow compliance is rated up to 8 GPH (30.28LPH). Running the pump at higher flow rates will not guaranteeAPI flow compliance and could result in pump damage. Consultfactory with questions regarding maximum flow rate.ID Plate Oil Fill Cap Pump AssemblyDrive EndPump AssemblyHydraulic End Pump AssemblyFluid EndRelief ValveDrainOutlet (both sides)Inlet (both sides)MT8 SpecificationPageOperation ................................................................................2Specifications ..........................................................................2Representative Drawings ........................................................5Safety Precautions ..................................................................6Installation ...............................................................................7Calibration ...............................................................................8Maintenance ............................................................................9Fluid End Parts List ...............................................................12Hydraulic End Parts List ........................................................14Drive End Parts List ..............................................................15Gearbox and Baseplate Parts List ........................................17Manual Adjust Gearbox Parts List ........................................18Troubleshooting .....................................................................19Replacement Parts Kits ....................................................... 20Manifold Pipe Plug Kits ........................................................ 20Warranty ................................................................................21