51GETTING TO KNOW YOUR ECS-9700/ 96002.6.2 Ignition Control WiringTo activate ignition control, you need to provide IGN signal via the 3-pinpluggable terminal block located in the back panel. It is below the general wiringconfiguration.For testing purpose, you can refer to the picture above to simulate ignitionsignal input controlled by a latching switch.Note:1. DC power source and IGN share the same ground.2. ECS-9700/9600 supports 6V~36V wide range DC power input in ATX/ATmode. In Ignition mode, the input voltage is fixed to 12V/24V for car batteryscenario.3. For proper ignition control, the power button setting should be “Power down”mode.In Windows, forexample, you needto set “When I pressthe power button” to"Shut down."Pin No. Definition1 Ignition (IGN)2 External Power S/W +3 External Power S/W +IGNV+
