Menu
UMENA PROSOLAR PATHMASTER User Manual
  |
Full product range & more information: www.lumenalights.comProducer Registration Numbers: WEE/KC3440XY / BPRN0843SOLAR TECHNOLOGY:The Pathmaster is a highly efficient solar light with high capacity LiFePO4 Lithium batteries and fast charging Monocrystallinesolar panel. Even on partially cloudy and rainy days, it will re-charge efficiently and will illuminate for many hours even after just1 hour charge in full sunshine. The 300 lumens light output is bright enough to illuminate paths and driveways, making them safeto navigate at night, with a downward spread light projection with minimal light pollution.INSTALLATION:Designed to be mounted onto decking, a patio or pathway, or into soft ground via the sturdy 4 fin anchored ground spike.For recommended spacing, see overleaf. Closer spacing / staggering will result in a more intense light.Location – It is important that the installation location is carefully considered, avoidingshady areas. Ensure there is no other lights which could interfere with the light,imitating daylight and forcing the light off.OPTIONAL: Apply a small amount of grease to the threads prior to installation toavoid seizing.MOUNTING BASE1. Use the base to mark the 3 mounting holes on the mounting surface in thedesired location.2. Remove the base and drill out the holes at the relevant depth and diameter forthe mounting screws / wall plugs being used (varies based on mountingsurface) – Anchor bolts recommended (10mm supplied).3. Replace the base to the desired location, lining up the 3 x holes and secure in placewith the chosen screws / bolts. - do not overtighten.4. Attach the base to the bottom of the tubular body (logo end) by turning clockwiseuntil secure – do not overtighten.5. Fasten the head to the tubular body (clockwise) until secure – do not overtighten.NOTE: Spacers may be beneficial between the surface and underside of the mounting base (6mm), depending on which type offixing bolts are used. This will prevent overtightening of screws and potential strain / damage to the base.GROUND SPIKE1. Dampen the area of installation to enable the spike to be pushed into the ground without too much resistance.2. Mount the spike into the ground by pushing firmly at the centre nut – do not use a blunt instrument or the outerthread could be damaged.3. Attach the threaded tubular body (logo end) to the ground spike by turning clockwise until secure –do not overtighten.4. Compact the earth around the fitting.5. Fasten the head to the tubular body (clockwise) until secure – do not overtighten.TURNING ON/OFF1) Remove the waterproof rubber bung located on the rim of the head labelled ON/OFF.2) Use a thin allen key or similar to pop in the power button inside the hole for power on– the light will flash on temporarily.3) Repeat to turn off. TIP: To check if the solar light is on, cover the solar panelNOTES: If the solar light is turned off, the battery will still charge.In particularly bad weather, turning the light off for 2 days will enable the battery to recharge without draining at night.If the battery reduces to 10% charge or less, the LED will also dim to 10%.STORAGE:When storing the bollard, be sure to turn the bollard to the off position by following the above steps (check by covering anduncovering the solar panel). Once pressed, the on/off button will release fully forward. Maximum 6 months storage when fullycharged – recharge will be required periodically to prevent damage to battery over long periods of time.Depth 10mm(screw position)88mm10.5mm 120mm75mm |
Related manuals for UMENA PROSOLAR PATHMASTER
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved