Menu
Radioddity PAX100 User Manual
Also see for PAX100: User manual
      |
drop and reduced power output.4. An accurate power meter that can read up to 150 watts. It has to be designed for 1.8 to30MHz.Operating:1. Wire it according to the picture. Adapter cables are provided to connect the G90 to theinput of the PAX-100. Then connect the output of the PAX to the antenna. Connect theDC power cable between your power supply and the amplifier.If using the APX-100 filter: Connect it’s DC power cord to the power supply.Double-check the positive and negative poles.2. Connect the Amplifier keying line (PTT trigger cable “C”) between the rear connector ofthe G90 and the “PTT trigger” two pin connector on the circuit board.3. Power on in the following order:Turn on the DC power supply - Turn on G90 (PAX100 will work automatically)2. Power setting:① Set the output power of G90 from 2-10W. 10W will provide max power output.② Press the PTT key of G90 to transmit. PAX100 will “key up” and amplify the outputpower to 80-100W.Accessories：Power cable A with 3 20AFusesInput & Output feeder B PTT Trigger Cable CProduct |
Related manuals for Radioddity PAX100
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved