The settings related to backing up or restoring settings data, and saving logs can be configured in this section.Backup• [Setup data]Click the [Execute] button to backup the setup data of the camera to a PC.• [Scene file]Click the [Execute] button to backup the scene files of the camera to a PC.• [Logs]Click the [Execute] button to backup the log data of the camera to a PC.IMPORTANT• When backing up settings or logs, creating the backup files takes time.• When the backup operation takes 10 minutes or more, a communication timeout may occur. In thiscase all of the backup data may not be obtained. Therefore, we recommend completing backupoperations within 10 minutes. It is also possible to check whether or not the correct data was obtainedby restoring the obtained data (excluding log data).Restore• [Setup data]Press the [Browse...] button and select the setup data files to restore.Click the radio button respective to the desired option to determine whether or not to also restore networkrelated setting contents.Click the [Execute] button to start restoring. Do not perform operations until the restoration is complete.(The camera will be rebooted when the restoration is complete.)Make sure to set the file name of setup data files used when restoring to “model name.dat”. (The modelname must be written in lower case letters and “WV-” is not needed.)• [Scene file]Press the [Browse...] button and select the scene files to restore.Click the [Execute] button to start restoring. Do not perform operations until the restoration is complete.Make sure to set the file name of scene file data used when restoring to “model name.txt”. (The modelname must be written in lower case letters and “WV-” is not needed.)194 Operating Instructions18 Maintenance of the camera [Maintenance]
