2The lightning flash with arrowhead symbol,within an equilateral triangle, is intended toalert the user to the presence of uninsulat-ed "dangerous voltage" within the prod-uct's enclosure that may be of sufficientmagnitude to constitute a risk of electricshock to persons.CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION:Before attempting to connect or operate this product, pleaseread the label on the bottom.The exclamation point within an equilateraltriangle is intended to alert the user to thepresence of important operating andmaintenance (servicing) instructions in theliterature accompanying the appliance.Power disconnection. Unit with or without ON-OFF switcheshave power supplied to the unit whenever the power cord isinserted into the power source; however, the unit is opera-tional only when the ON-OFF switch is in the ON position.Unplug the power cord to disconnect the main power for allunits.WARNING:• This apparatus must be earthed.• Apparatus shall be connected to a main socket outlet with aprotective earthing connection.• The mains plug or an appliance coupler shall remain readilyoperable.• To prevent fire or electric shock hazard, do not expose thisapparatus to rain or moisture.• The apparatus should not be exposed to dripping or splash-ing and that no objects filled with liquids, such as vases,should be placed on the apparatus.• All work related to the installation of this product should bemade by qualified service personnel or system installers.• For PERMANENTLY CONNECTED APPARATUS provided nei-ther with an all-pole MAINS SWITCH nor an all-all pole circuitbreaker, the installation shall be carried out in accordancewith all applicable installation rules.• The connections should comply with local electrical code. FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXTCAREFULLY.This appliance is supplied with a moulded three pin mains plug for yoursafety and convenience.A 5 amp fuse is fitted in this plug.Should the fuse need to be replaced please ensure that the replacementfuse has a rating of 5 amp and that it is approved by ASTA or BSI toBS1362.Check for the ASTA mark or the BSI mark on the body of thefuse.If the plug contains a removable fuse cover you must ensure that it isrefitted when the fuse is replaced.If you lose the fuse cover the plug must not be used until a replacementcover is obtained.A replacement fuse cover can be purchased from your local PanasonicDealer.IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THESOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BEREMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUTOFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.How to replace the fuseThe location of the differs according to the type of AC mains plug (fig-ures A and B).Confirm the AC mains plug fitted and follow the instructions below.Illustrations may differ from actual AC mains plug.Open the fuse cover with a screwdriver and replace the fuse and closeor attach the fuse cover.Figure A Figure BFor U.K.Safety InformationIn English: “The equipment must be connected to an earthedmains socket-outlet”.In Danish: “Apparatets stikprop skal tilsluttes en stikkontaktmed jord, som giver forbindelse til stikproppens jord”.In Finnish: “Laite on liitettävä suojakoskettimilla varustettuunpistorasiaan”.In Norwegian: “Apparatet må tilkoples jordet stikkontakt”.In Swedish: “Apparaten skall anslutas till jordat uttag”.For Denmark, Finland, Norway, Sweden: Alternating current symbol