Panasonic Viera TX-26LXD7 Operating Instructions Manual

Also see for TX-32LXD7M: Service manual

Panasonic Viera TX-26LXD7 Operating Instructions Manual Manual pdf 32 page image

32OffDVB Signal ConditionDVB Programme [70] CBBC Channel0 5 10Signal QualitySignal StrengthSelects a channel and checks the DVB signal condition.Use for adjusting the direction of the aerial.Signal Quality:• Green bar Good• Yellow bar Poor• Red bar Bad (Check the aerial)• To change the programme during the menu appearsCheckDVB signalDVB SignalConditionDisplay anotificationmessage New DVB Service Found!Press OK to start Auto SetupPress EXIT to lgnore.Selecting Auto Setup will deletecurrent Profile and Childlock settingsSelects whether to give a notification message when a new DVB service is found. (Off / On)• Selecting OK (Auto Setup) will deletecurrent Profile and Childlock settings.New ServiceMessageAddDVB channelautomaticallyAny new services found will be added to the DVB Service List (p. 29) automatically.ADD New DVB ServicesPlease waitThis will take about 3 mins.21 68Prog. Channel Service Name Net ID. TS ID. QualityZDFARDstart• The new service is added with the currentsettings saved as they are.Add NewDVB ServicesSet DVBchannelmanuallyDVB ManualTuningselect channelsearchDVB Manual TuningSignal QualityStopped0 10Signal Strength 0 10Frequency MHz[CH21] 474,00Prog. Channel Net ID. QualityTS ID.Service NameNormally use “Auto Setup” or “Add New DVB Services” for the DVB channel setting.If tuning has not done completely, use this function.• All services found will be added to theDVB Service List (p. 29) automatically.Set AnaloguechannelmanuallyAnalogueManual TuningProgramme 1 BBC1 [CH33]Analogue Manual TuningManual Tuning 21 68Set Analogue channel manually after Auto Setup.If a VCR is connected with only the RF cable, select programme position “0”.storesearchSelect the channel Search and storeSelect the programme positionVCR1 324 657 980Tuning Channels