Panasonic Viera TH-P58V10A Operating Instructions Manual

Panasonic Viera TH-P58V10A Operating Instructions Manual Manual pdf 39 page image

VIERA Link “HDAVI Control TM”39 AdvancedNoteThis function may not work properly depending on the connected equipment.For DIGA Recorder / DVD Player / Blu-ray Disc Player / HD Video Camera / LUMIX Camera with VIERA Linkfunction, connect to HDMI1, HDMI2, HDMI3 or HDMI4 terminal via an HDMI cable.For Player theatre / Blu-ray Disc theatre / Amplifier, connect to HDMI1, HDMI2, HDMI3 or HDMI4 terminal via anHDMI cable and/or either the optical digital audio cable or RCA cable for audio output from the TV.Use fully wired HDMI compliant cable. Non-HDMI-compliant cables cannot be utilized.Recommended Panasonic’s HDMI cable part number:• RP-CDHG10 (1.0 m) • RP-CDHG15 (1.5 m) • RP-CDHG20 (2.0 m) • RP-CDHG30 (3.0 m) • RP-CDHG50 (5.0 m)●●●●PreparationsConnect the equipment supporting VIERA Link.Set up the connected equipment. Read the manual of the equipment.For optimal recording, the settings of the recorder might be required. For details, read the manual of therecorder.Set VIERA Link On in Setup Menu “VIERA Link” (p. 25)Set up the TV After connection, turn the equipment on and then switch the TV on. Select the inputmode to HDMI1, HDMI2, HDMI3 or HDMI4 (p. 20), and make sure that an image is displayed correctly.This setup should be done each time when the following conditions occur:• for the first time • when adding or reconnecting equipment • when changing setup●●●●●Features availableChannel downloadChannel setting can be downloaded to the recorder.Easy playbackAutomatic input switching - When the connected equipment is operated, input mode is switchedautomatically.Power on linkSet Power on Link “On” in Setup Menu to use this function “Power on Link” (p. 25)When the connected equipment starts playback or direct navigator / function menu for the equipmentare activated, the TV is automatically turned on. (Only when the TV is in Standby mode.)Power off linkSet Power off Link “On” in Setup Menu to use this function “Power off Link” (p. 25)When the TV is set to Standby mode, the connected equipment is also automatically set to Standby.This function will work even if the TV enters standby mode automatically by Off Timer function or auto powerstandby function.●Reduce unnecessary power consumption in standby Standby Power SaveSet Standby Power Save “On” in the Setup Menu to use this function“Standby Power Save” (p. 25)The power consumption in Standby mode of the connected equipment is controlled higher or lower insynchronization with the TV On / Off state to reduce the consumption.When the TV is set to Standby mode, the connected equipment is automatically set to Standby andthe power consumption in Standby mode of the connected equipment is automatically minimized.When the TV is turned on, the connected equipment is still in Standby mode, but the powerconsumption is increased to make startup time early.This function is effective if the connected equipment can change the power consumption in Standby modeand is set to higher consumption.●Auto standby for unnecessary equipment Intelligent Auto StandbySet Intelligent Auto Standby “On (With reminder)” or “On (No reminder)” in the Setup Menu touse this function “Intelligent Auto Standby” (p. 25)When the TV is on, the connected equipments not in use go into Standby mode automatically toreduce the power consumption.If you select “On (With reminder)”, the on screen message will be displayed to be noticed before working thisfunction.●