50FAQsProblem ActionsChaotic image, noisyChange the setting of “P-NR” in the Picture Menu (to removenoise). (p. 24)Check nearby electrical products (car, motorcycle, fluorescentlamp).●●No image can be displayed Is “Colour” or “Contrast” in the Picture Menu set to the minimum?(p. 24)●Blurry or distorted image(no sound or low volume) Reset channel. (p. 31)●Unusual image is displayed Turn off the TV with Mains power On / Off switch, then turn it onagain.●No sound is produced Is “Sound Mute” active? (p. 10)Is the volume set to the minimum?●●Sound level is lowor sound is distortedSound signal reception may be deteriorated.Set “MPX” (p. 24) in the Sound Menu to “Mono”.●●Sound is unusualSet the sound setting of the connected equipment to “2ch L.PCM”.Check the “HDMI1 / 4 Input” setting in the Sound Menu. (p. 24)If digital sound connection has a problem, select analogue soundconnection. (p. 36, 47)●●●Pictures from external equipmentare unusual when the equipmentis connected via HDMIIs the HDMI cable connected properly? (p. 47)Turn Off the TV and equipment, then turn them On again.Check an input signal from the equipment. (p. 48)Use an equipment compliant with EIA/CEA-861/861B.●●●●TV goes into “Standby mode” Off Timer function is activated.The TV enters “Standby mode” about 30 mins. after analoguebroadcasting ends.●●The remote control does notworkAre the batteries installed correctly? (p. 7)Has the TV been switched On?●●HDMI SoundOther Screen