Panasonic Viera TC-P55VT30 User Manual

Also see for VIERA TC-P50GT30: Owner's manual Specification sheet Owner's manual Owner's manual Service manual

Panasonic Viera TC-P55VT30 User Manual Manual pdf 62 page image

62Disposal 3D EyewearA lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations.When disposing this product, disassemble properly by following the procedure below, and remove the internalrechargeable battery.Do not disassemble this product except when disposing of it.Danger● As the rechargeable battery is specifically for this product, do not use it for any other device.• Do not charge the removed battery.• Do not throw the battery in a fire, or apply heat to it.• Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.• Do not let the wires touch any other metal or each other.• Do not carry or store the battery with a necklace, hair pin, or the like.• Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun.Doing so may cause the battery to generate heat, ignite, or rupture.Warning● Do not place the removed battery, screws, and other items within reach of infants.Accidental swallowing of such an item may have an adverse effect on the body.• In the event that you think such an item has been swallowed, consult a doctor immediately.● In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with barehands.Fluid entering into an eye may cause loss of eyesight.• Wash the eye with water immediately without rubbing it, and then consult a doctor.Fluid getting on your body or clothes may cause inflammation of the skin or injury.• Sufficiently rinse with clean water, and then consult a doctor.How to remove the batteryDisassemble this product after the battery has run out of power.The following figures are intended to explain how to dispose of the product, not for describing how to repair.The product cannot be repaired once it has been disassembled.1. Fold the part of theframe without the powerswitch, and then removethe two screws on theinside of the hinge with aprecision Phillips (plus + )screwdriver.ScrewsFrame3. Remove the battery frominside the side cover, andcut the two wires one by onewith scissors.• Insulate the wire parts ofthe removed battery withcellophane tape.2. Bend the frame inwardsand pull it off from the sidecover.• If it is difficult to remove,insert a flat-blade (minus - )screwdriver and force it off.Side coverBatteryNote● Take sufficient care when performing this work so as notto injure yourself.● Do not damage or dismantle the battery.