Panasonic Viera Link TH-42PZ80U Quick Start Manual

Also see for Viera Link TH-42PZ80U: Operating instructions Technical guide Troubleshooting guide Service manual Operating instructions

Panasonic Viera Link TH-42PZ80U Quick Start Manual Manual pdf 33 page image

33AdvancedEditing and Setting ChannelsAutomatically searches and adds available channels to the memory.Select “ANT in”Select Cable or Antenna (p. 15)Select “Auto”Program channelCableANT inAutoManualSignal meternextselectSelect a scanning mode (p. 15)Auto programAll channelsAnalog onlyDigital onlyokselectSettings are made automaticallyAfter the scanning is completed, select “Apply”.(see below ).All previously saved channels are erased.Use this procedure when changing the channel setup orchanging the channel display.Also, use this to add or skip channels from the channellist manually.You can select a channel tuning mode (Digital only/Analog only) in “Surf mode”(p. 25)EditCaptionCaption selectCaptionCaption detail---Apply Cancelselectchangeset/nextCaptionSelect the station identifierCaption detailRename (maximum 7 characters available)FavoriteSet favorite 1/31226-1 - - -selectnextSet favorite Select the numberAddPress OK to select “Yes (add)” or “No (skip)”Move cursor to channel numberEditCaption Favorite AddApply CancelManual program2 ...... Yes3 ...... YesCannnelselectPress OK to tuneto the channel.Select “Apply”Caption Favorite AddApply Cancelprogram.... Yesselect “Apply”okSelect “Edit”EditCannnel Caption Favorite AddApply CancelManual program2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesselectnextSelect the item to be editedEditCaption Favorite AddApply CancelManual program2 ...... YesSelectOKRETURN Prev. pageR Next pageG B Y3 ...... Yes4 ...... Yes5 ...... Yes6 ...... Yes7 ...... Yes8 ...... Yes9 ...... YesCannnelCaptionFavoriteAddProceed tonext pageGo back to previous pageselect the item to edit(Caption/Favorite/Add)next• Caption:Changes the station identifier• Favorite:Registers channel to FavoriteList• Add:Adds or skips channelsTo cancel the EditEditCaption Favorite AddApply CancelManual program2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesCannnelselectnextChanges will be lost. Continue?Yes Nook(returns to “Programchannel”)select “Yes”Check the signal strength if interference is found or freezing occurs on a digital image.Signal meterSignal strength1-1ChannelCurrentPeak level30%45%Signal intensitychangechannelokorIf the signal is weak, check the antenna.If no problem is found, consult your local dealer.NoteNot available if “Cable” is selected in “ANT in”(see above).Available only for digital antenna channels.If “Lock” (p. 30) is activated and “Program channel” is selected, “Enter password.” will be displayed.