Panasonic VL-MC3000BX Operation Instruction Manual

Panasonic VL-MC3000BX Operation Instruction Manual Manual pdf 2 page image

BracketResistance: for setting up defense zoneequipment2Wire connector, AWG26: for power port182Wire connector, AWG28: for doorbell port(if support this port)10Wire connector, AWG28: for alarm portScrew M4*16: Locked the bracket to the 86box1112Part CountNameThe following items are included in addition to the room monitor.1. Including items2. Important informationWARNINGPreventing fire, electric shock, and short circuits.・Leave installation work to the dealer. Installation work requirestechnical knowledge and experience. Electrical connection workshould be performed by certified personnel only. Failure to obser-ve this may cause fire, electric shock, injury, or damage to theproduct. Consult the dealer.・Use only the power supply unit VL-PC3400ler.・Do not place objects on the power cables. Install the productwhere no one can step or trip on the power cables.To prevent severe injury or loss of life or property, and to ensureproper and safe operation of your product, read this section carefu-lly before using the product.2.1 Important safety information1 2・Do not allow the power cables to be excessively pulled, vent orplaced under heavy objects.・Make sure all connections from the power outlet to the powersupply unit are secure.・Never touch the power supply unit and power cables with wethands.・Do not use the power supply unit for outdoor installations (it isfor indoor use only).・Do not disassemble or modify the product. Refer servicing to anauthorised service centre when service is required. Disassembl-ing the product or manipulating the product in a way notdescribed in the documentation may expose you to dangerousvoltages and other risks.・Do not touch the product or the power supply unit during anelectrical storm. There may be a remote risk of electric shockfrom lightning.・Never install wiring during a lightning storm.・Do not connect non-specified devices.・When opening holes in walls for installation or wiring, or whensecuring the power cable, make sure you do not damage existingwiring and ductwork.・Do not make any wiring connections when the power outlet isturned on.・Do not install the product and power supply unit in the followingplaces:‒ Places where the product and power supply unit may be splas-hed with water or chemicals‒ Places where there is a high concentration of dust or high hum-idity・Do not push any objects through the openings of the product.・If any of the following conditions occur, disconnect the Ethernet(LAN) cable from the product,disconnect the power supply unitfrom the power outlet, and then refer servicing to an authorisedservice centre.