Panasonic Toughbook CF-U1AQB1G2M Supplementary Instructions Manual

Also see for CF-U1 series: Operating instructions Reference manual Specification sheet Operating instructions Reference manual

Contents

Panasonic Toughbook CF-U1AQB1G2M Supplementary Instructions Manual Manual pdf 3 page image

3ENGLISHThe following menu opens by clicking icon on the notification area.Connection to Barcode(Power Saving Mode)Connection to Barcode(Always-On)Disconnect Barcode ModuleConfirmation Message OnAllow Code 39Packet ModeExit 2D Barcode Key EmulatorTo reduce the power consumption, stop barcode readerconnection within 1 minute after reading a barcode.Keep barcode reader active even after reading a barcode.Stop barcode reader connection in Always-On mode orPower Saving Mode.If the trigger button is pressed in Power Saving Mode, “PushBarcode Trigger again to enable Barcode.” message is dis-played to prevent operational errors.*1Allow Code 39 type barcode. You can change the settingby scanning Enable/Disable of Code39 ( Page 7).Receive barcode decode data in packet mode.Exit barcode reader operation.When the computer enters Sleep (Model with Windows Vista)/Standby (Model withWindows XP) or Hibernation in Power Saving Mode or Always-On mode, the BarcodeReader is disabled. [Barcode Module was disconnected by changing the power status]message appears at the next resume timing.• In Power Saving Mode, click [OK] to reconnect with the Barcode Module.• In Always-On mode, click [OK] and select [Connection to Barcode (Always-On)] againfrom the above menu to reconnect with the Barcode Module.When the computer is shut down in Power Saving Mode or Always-On mode, theBarcode Reader is disabled.• In Power Saving Mode, just turn on the computer to reconnect with the BarcodeModule.• In Always-On mode, the Barcode Module is not reconnected only by turning on thecomputer. Select [Connection to Barcode (Always-On)] again from the above menu.The icon may not appear when you start up the computer for the first time. In thiscase, restart the computer.NOTE*1 The confirm message is closed in the following cases.• When five seconds pass from the display message.• When the [Close] in the message window is clicked.• When the trigger button is pushed again.Setting for Barcode Reader