10Using the Touch PadC Conduct steps 3 to 4 above.D Click [Virtual Scrolling], remove a check mark from [Enable vertical scrolling] and [Enable horizontal scrolling], thenclick [OK].E Click [OK] at [Mouse Properties].F Click [start] - [All Programs] - [Panasonic] - [Touch Pad utility settings].G Click [General settings], add a check mark for [Use Touch Pad function], then click [OK].Adjust [PalmCheck] and [Touch Sensitivity] using the following procedure:1 Click [start] - [Control Panel] - [Printers and Other Hardware] - [Mouse] - [Device Set-tings].2 Click the device name (e.g. Synaptics TouchPad) in [Devices], then click [Settings].3 Double-click [Sensitivity], then click [PalmCheck] or [Touch Sensitivity].4 After making the adjustment, click [OK]. PalmCheck™z When operating the keyboard, if your hand touches the Touch Pad unintentionally causing the cursor to move, adjust thesensitivity using “PalmCheck™.”• By dragging slide bar to the [Maximum] position, you can prevent the cursor from moving unintentionally.• By dragging slide bar to the [Minimum] position, you can enable the cursor to move even with a light touch of the palmon the Touch Pad. Touch Sensitivityz When operating the Touch Pad, if your finger touches the Touch Pad, unintentionally causing the cursor to move; or if thecursor does not move even when you move your finger on the Touch Pad, adjust the sensitivity using the “Touch Sensitiv-ity”.• By dragging slide bar to the [Heavy Touch] position, the cursor will only move with a strong touch on the Touch Pad.• By dragging slide bar to the [Light Touch] position, the cursor will move even with a light touch on the Touch Pad.z By design, the Touch Pad is to be used with a fingertip only. Do not place any object on the work surface or press downforcefully with sharp-pointed objects (e.g., nails) or hard objects that can leave marks (e.g., pencils and ball point pens).Adjusting the Sensitivity when Touching the Touch PadHandling the Touch Pad