Panasonic TX-26LX70 Operating Instructions Manual

Panasonic TX-26LX70 Operating Instructions Manual Manual pdf 38 page image

38Problem ActionsScreen Sound HDMIChaotic image, noisy • Set “P-NR” in the Picture Menu (to remove noise). (p. 20)• Check nearby electrical products(car, motorcycle, fluorescent lamp).No image can bedisplayed • Is “Colour” or “Contrast” in the Picture Menu set to the minimum?(p. 20)• Check Colour system. (p. 23)Blurry or distorted image(no sound or low volume) • Reset channels. (p. 22)No sound is produced • Is “Sound mute” active? (p. 7)• Is the volume set to the minimum?Sound level is lowor sound is distorted • Sound signal reception may be deteriorated.• Set “MPX” (p. 20) in the Sound Menu to “Mono”.• Check Sound system. (p. 23)Sound is unusual• Set the sound setting of the connected equipment to“2ch L.PCM”.• Check the “HDMI1 Input” setting in the Sound Menu. (p. 20)• If digital sound connection has a problem, select analogue soundconnection. (p. 29)Pictures from externalequipment are unusualwhen the equipment isconnected via HDMI• Is the HDMI cable connected properly? (p. 32)• Turn Off the TV and equipment, then turn them On again.• Check an input signal from the equipment. (p. 36)• Use an equipment compliant with EIA/CEA-861/861B.Unusual image is displayed • Turn off the TV with Mains power On / Off switch, then turn it onagain.TV goes into“Standby mode” • Off Timer function is activated.• The TV enters “Standby mode” about 30 min. after broadcastingends.The remote controldoes not work • Are the batteries installed correctly? (p. 6)• Has the TV been switched On?OtherAn error message appears • Follow the message’s instructions.• If the problem persists, contact the authorized Service Centre.FAQs

/ 40

Related manuals for Panasonic TX-26LX70