6Quick Start GuideDOWNLOAD IN PROGRESSPLEASE WAITProgramme : 63Remote control unavailableTV to VCR or DVD Recorder DownloadIf a “Q-Link”, “NEXTVIEWLINK” or compatible recording device has beenconnected to a Scart terminal before starting Step , programme informationwill be downloaded to that device.4The programme positions will be downloaded to the recording device, in the same order as stored in the TV.See page 17.Not all VCRs / DVD Recorders support this download of programme information, some may require to bestarted manually.Refer to the recording device’s operating instruction book.If a recording device other than those described above has been connected, then there will be no downloadoperation.Notes:• If the recording device has not accepted download data from the TV, you may need to select the Downloadoption from the device’s menu system. Refer to the recording device’s operating instruction book.• If Q-Link is not operating correctly, check the following:The Scart cable is connected to the TV’s Scart terminal, AV1 or AV, and correctly setup in the menu.The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similartechnology) Scart terminal.The Scart cable is a “fully wired” type.• For further information on Q-Link and connecting equipment, see page 17, 5, 8.AUTO SETUP IN PROGRESSSEARCHING : PLEASE WAIT02 99:21 41CH12ExitGreenRedSuchlaufStart ATP AbbruchAuswählenDeutschlandÖsterreichFranceItaliaEspañaPortugalNederlandDanmarkSverigeNorgeSuomiBelgienSchweizELLADAPolskaČeská republikaMagyarországE.EuLand OSD SpracheDeutsch3 Select your country.For Belgium, Switzerland and E.Eu, selectthe desired language.If you wish to perform manual tuning, pressthe Green button.See page 16.Press the Red button to start Auto Setup.Auto setup will begin, your stations will belocated and stored.If a compatible recording device is connectedto the correct Scart terminal, programmedata will be downloaded to the device viaQ-Link.See page 17.TVN1 2 34 5 67 8 9C 0OK