Panasonic TH-50PF30U Service Manual

Also see for TH-50PF30U: Operating instructions Operating instructions Service manual

Contents

Panasonic TH-50PF30U Service Manual Manual pdf 13 page image

TH-50PF30U6.1.2. CD modeSelect the CD mode by Up/Down button on the remote control at the front page of CAT mode and then press the Mute button onthe remote control more than 3 seconds.CDMON1TOR-MCU 1. 0000F30 | OK :--------------- 1-----------'-tMONITOR-EEPROM 55. 55 1 i CA F9 :-i -------------- 1—MONITOR-EEPROM Change AddrООоDataГПо»оLAN-MCU 1. 0000X20LAN-MAC ADDRESS 00:0В:97:7С:72:А9PANEL-MCU 51.56PANEL-EEPROM 73.09PANEL-DCC 31.20PANEL-PDROM 79.25SLOT BOARD EEPROM ------- -------SLOT BOARDPTCT 00. 00. 00. 00. 00. *-- Factory use-- New data-- Original data--- SOS historyMemory data changeAddress . Change by Up/Down buttons on theremote control.Change by Left/Right buttons on the remote control.Data 0 0 ■Change by VOL Up/Down buttons on theremote control.The data is memorized when switch off the main power.To exit the CD mode, press the R button on the remote control.6.1.3. NW modeNote :To use the network function, set each "N etwork Setup" setting and make sure to set the "Control I/F Select" to "LAN".Select the NW mode by Up/Down button on the remote control at the front page of CAT mode and then press the Action buttononthe remote control.To exit the NW mode, press the R button on the remote control.13