Panasonic TC-P46G15 Operating Instructions Manual

Also see for Viera TC-P42G15: Revised troubleshooting handbook Quick setup guide Specifications Operating instructions Operating instructions

Panasonic TC-P46G15 Operating Instructions Manual Manual pdf 51 page image

51AdvancedEditing and Setting ChannelsAutomatically searches and adds available channels to the memory.Select “ANT in”Select Cable or AntennaOr select “Not used” (p. 16).Select “Auto program”CableANT/Cable setupANT inAuto programManual programSignal meternextselectSelect a scanning mode (p. 17)Auto programAll channelsAnalog onlyDigital onlyokselectSettings are made automaticallyAfter the scanning is completed, select “Apply”.(see below ).All previously saved channels are erased.Use this procedure when changing the channel setup orchanging the channel display.Also, use this to add or skip channels from the channellist manually.You can select a channel tuning mode (Digital only/Analog only) in “Channel surf mode” (p. 36)EditCaption---80-101ChangeOKRETURNDeleteABC → abcG YEdit CH captionCaptionChannelselectchangeset/nextorCaptionSelect the station identifier (maximum 7 characters available)FavoriteSet favorite 1/326-112selectnextSet favorite Select the numberAddPress OK to select “Yes (add)” or “No (skip)”Move cursor to channel numberManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... YesChannelselectPress OK to tuneto the channel.Select “Apply”programCancelApplyCaption Favorite Add...... Yeselselect “Apply”okSelect “Edit”Manual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesChannelselectnextSelect the item to be editedR G B YSelectRETURNOKManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... Yes6 ...... Yes7 ...... Yes8 ...... Yes9 ...... YesChannelPrev.page Next pageCaptionFavoriteAddProceed tonext pageGo back to previous pageselect the itemto edit (Caption/Favorite/Add)next• Caption:Changes the station identifier• Favorite:Registers channel to FavoriteList• Add:Adds or skips channelsTo cancel the EditManual programEdit CancelApplyCaption Favorite Add2 ...... Yes3 ...... Yes4 ...... Yes5 ...... YesChannel selectnextChanges will be lost. Continue?Yes No ok(returns to “ANT/Cable setup”)select “Yes”Check the signal strength if an interference is found or freezing occurs on a digital image.1-1Signal meterChannelTune manuallySignal strengthCurrent 30%Peak level 45% Signal intensitychangechannelokorIf the signal is weak, check the antenna.If no problem is found, consult your local dealer.NoteNot available if “Cable” is selected in “ANT in”(see above).Available only for digital antenna channels.If “Lock” (p. 48) is activated and “ANT/Cable setup” is selected, “Enter password.” will be displayed.