Panasonic TC-P42C1 Operating Instructions Manual

Also see for TC-P42C1 - 41.6" Plasma TV: Quick setup guide Specifications Service manual Operating instructions Revised troubleshooting handbook

Panasonic TC-P42C1 Operating Instructions Manual Manual pdf 5 page image

5WARNINGSmall parts can present choking hazard if accidentallyswallowed.Keep small parts away from young children.Discard unneeded small parts and other objects, includingpackaging materials and plastic bags/sheets to preventthem from being played with by young children, creatingthe potential risk of suffocation.Set upThis Plasma TV may fall and can cause personal injury oreven death if not installed correctly. To prevent personal injuryor death, follow these warnings:Install the Plasma TV in accordance with themanufacturer’s recommended pedestal or stand,corresponding hardware and installation instructions.This Plasma TV is for use only with the following optionalaccessories. Use with any other type of optional accessoriesmay cause instability. The following accessories aremanufactured by Panasonic Corporation.• Wall-hanging bracket (Angled) TY-WK4P1RWBe sure to ask a qualified technician to carry out theinstallation and set-up.Two or more people are required to install or remove thetelevision.Some wall mounts (wall-hanging brackets) are notdesigned to be mounted to walls with steel studs or oldcinder block constructions.Ask your dealer or licensed contractor to properly secure thewall-hanging bracket.Do not place the Plasma TV or its stand on a sloped orunstable surface.The Plasma TV may fall or tip over.Do not support the Plasma TV on a non-specifiedpedestal.Do not place the Plasma TV on furniture that can easilybe used as steps, such as a chest of drawers.Do not climb or allow children to climb on the Plasma TVPlace or install the Plasma TV where it cannot be pushed,pulled over or knocked down.Route all cords and cables such that they cannot betripped over or pulled by curious children.Do not place any objects on top of the Plasma TV.If water spills onto the Plasma TV or foreign objects getinside it, a short-circuit may occur which could result in fireor electric shock. If any foreign objects get inside the PlasmaTV, please consult an Authorized Service Center.AC Power Supply CordTo prevent fire or electric shock:The Plasma TV is designed to operate on a 120 V AC,60 Hz service. Insert the power cord plug as far as it willgo into the wall socket.If the plug is not fully inserted, heat may generate, whichcould cause a fire.The included power cord is for use with this unit only.Do not use any power cord other than that provided withthis TV.Do not handle the power cord plug with wet hands.Do not do anything that might damage the power supplycord.When disconnecting the power supply cord, hold theplug, not the cord.Do not use the power supply cord if the plug or cord isdamaged.Replace the cord or contact your Authorized Service CenterHandling the power supply cordInsert the power plug fully into the socket outlet. (If thepower plug is loose, it could generate heat and cause fire.)Ensure that the power plug is easily accessible.Ensure the earth pin on the power plug is securelyconnected to prevent electrical shock.• An apparatus with CLASS I construction shall be connected toa power socket outlet with a protective earthing connection.Do not touch the power plug with a wet hand. (This maycause electrical shock.)Do not use any power cord other than that provided withthis TV. (This may cause fire or electrical shock.)Do not damage the power cord. (A damaged cord maycause fire or electrical shock.)• Do not move the TV with the cord plugged in the socket outlet.• Do not place a heavy object on the cord or place the cordnear a high-temperature object.• Do not twist the cord, bend it excessively, or stretch it.• Do not pull on the cord. Hold onto the power plug bodywhen disconnecting cord.• Do not use a damaged power plug or socket outlet.If Problems Occur During UseIf a problem occurs (such as no picture or no sound),or if smoke or an abnormal odor is detected from thePlasma TV, unplug the power supply cord immediately.Continued use of the TV under these conditions might causea fire or permanent damage to the TV. Have the TV evaluatedby an Authorized Service Center. Servicing of the TV byunauthorized personnel is strongly discouraged due to itshigh voltage.If water or an object get inside the Plasma TV, if thePlasma TV is dropped, or if the enclosure becomesdamaged, unplug the power supply cord immediately.A short-circuit may occur, which could cause a fire. Contactan Authorized Service Center for an evaluation.CAUTIONDo not cover the ventilation holes.Doing so may cause the Plasma TV to overheat, which cancause a fire or damage to the Plasma TV.Leave a space of 3 15/16” (10 cm) or more at the top, leftand right, and 2 3/4” (7 cm) or more at the rear.When using the pedestal, keep the space between thebottom of the TV and the pedestal or stand surface clearfrom objects that may obstruct ventilation.When Moving the Plasma TVBe sure to disconnect all cables before moving thePlasma TV.Moving the TV with its cables attached might damage thecables which, in turn, can cause fire or electric shockTo prevent an electric shock, disconnect the powerplug from the wall outlet as a safety precaution beforecarrying out any cleaning.WARNING/CAUTION