4. Press key (“AOK ” or “ANG ” changes to “T2E ”).5. After the adjustment is finished, remove the disc.6.2.5. Playback-only disc automatic adjustment1. Have “T3E ” indicated on display, set the playback-only disc.(Check to make sure the disc is properly seated.)2. Press key of the remote controller. The adjustment is started.3. During adjustment. “AADJ ” is displayed on the LCD of the remote controller.If there is no abnormality, “AOK ” will be displayed.Note:If it is displayed “ONG ”, check “7. Troubleshooting Guide” in the order.4. Press key (“OOK ” or “ONG ” changes to “T3E ”).5. After the adjustment is finished, remove the disc.6.2.6. How to get out the adjustment modeRemove the battery when you finish the adjustment.6.3. Checking the main unit's keys1. Set the battery and connect the remote controller.2. Turn off the power, and switch main unit’s HOLD switch OFF.3. Press the VOL+, VOL-, , and keys on the remote controller withintwo seconds. (as shown in Fig. 5 )4. When the unit enters the unit key check mode, the display shows “T KEX ”.While “T KEX ” is displayed, press the , , and VOL(+, -) keysof the unit in the specified order and then switch off the HOLD switch.*When thefirst key is pressed, the display will change to “T ”.32