3. Laser power meter (LE8010 or compatible meter)4. Remote controller6.2. Laser power adjustment, Off-set automatic adjustment,Playback-only disc/magneto-optical disc automaticadjustment magnet6.2.1. Enter the adjustment modeCaution:Place the unit on the insulation sheet with the disc cover side facing up.1. Disassemble the unit so that only the mechanism unit and the printed circuitboard are exposed.(Refer to (Step1) of the main part replacement procedure “5.2. Replacementfor the intermediate cabinet”).2. Move the optical pickup to the innermost side and attach the disc cover.3. Set the battery and connect the remote controller.4. Turn off the power, and switch main unit’s HOLD switch off.5. Press the VOL+, VOL-, , and keys on the remote controller withintwo seconds. (as shown in Fig. 5 )Fig. 56. When the adjustment mode is activated, “T0E ” will be displayed on the LCDof remote controller. After “T0E ” is displayed, select the desired adjustmentitem with the button or button of the remote controller. (If it is notdisplayed, perform the procedures written above again.)26