21 Specifications2 Disassembly and Assembly InstructionsCaution Note:• This section describes procedures for checking the operation and replacing the main components.• For reassembly after operation checks or replacement, reverse the respective procedures.• Special reassembly procedures are described only when required.• Before carrying out the disassembly process, please ensure all the safety precautions & procedures are followed.• During the disassembly and/or assembly process, please handle with care as there may be chassis components with sharpedges.• During replacement of component parts, please refer to the section of “Replacement Parts List” as described in the service man-ual.• Select items from the following indexes when disassembly or replacement are required.Speakers (SB-MAF7000PU/GS, SB-MAG7000PU/GS)• Disassembly of Front Panel Block• Disassembly of Tweeter Speaker (SP1)• Disassembly of Woofer Speaker (SP2)• Disassembly of Lighting Wire P.C.B. AssemblySubwoofer Speaker (SB-MAW7000PU/GS)• Disassembly of Front Panel Block• Disassembly of Subwoofer Speaker (SP3)• Disassembly of Lighting Wire P.C.B. AssemblySpeakers (SB-MAF7000PU/GS, SB-MAG7000PU/GS)Speaker unit(s)Tweeter 6 cm cone typeWoofer 20 cm cone typeImpedance 3 ΩDimensions (W x H x D) 407 mm x 260 mm x 258 mmMass 5.5 kgSubwoofer Speaker (SB-MAW7000PU/GS)Speaker unit(s)Super Woofer 30 cm Cone typeImpedance 6 ΩDimensions (W x H x D) 402 mm x 450 mm x 386 mmMass 13 kgNotes:1. Specifications are subject to change without notice.Mass and dimensions are approximate.2. Total harmonic distortion is measured by the digital spectrum ana-lyzer.