12RQT51897371○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○72○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○CDsProgram playSelect up to 36 tracks to play in the order you choose.On the main unitPreparation: Press [ … TAPE/CD] to switch to CD mode.1 Turn [TIME/PRESET TUNE CD SKIP ] to selectthe track.2 Press [•MEMORY*****CLEAR].Repeat step 1 and 2 to program other tracks.3 Press [¤/g CD] to start play.On the remote controlPreparation:Press [ … ] to switch to CD mode.1 Press [PGM/*****CLEAR].“ ” appears on the display.2 Enter the track number with the numbered but-tons.For tracks numbered 10 and over, press [≥10] then the twodigits.Repeat this step to program other tracks.3 Press [CD] to start play.The program remains intact even if play is stopped or the unit isturned off. “Cd-P” appears when play is stopped to indicate the con-tents are in the memory.To cancelPress and hold [•MEMORY – CLEAR] (remote control: [PGM/*****CLEAR]) in the stop mode until “CLEAR” is displayed.The mode is also cancelled if the CD tray is opened.“FULL” is displayedIf 36 tracks have already been programmed.“– –:– –” is displayedIf the total play time of the program exceeds 100 minutes.You can still program and play tracks.A To check the program contents (while “Cd-P” is dis-played)Turn [TIME/PRESET TUNE CD SKIP ].On the remote controlPress [S / 44444] or [33333 / T].ListeningTrack number Play timeProgrammed track Play sequence7273 71TAPE ⁄ CDC D2 3 PGM/-CLEAR15 6 ≥1048 9 07C RESET RANDOM REPEATFM MODE/BPPRESET EQS.VIRTUALIZERPRESET TUNECD SKIPAUTO SCANVOLUMETAPE TUNER CDREW FF2 13○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○2 315 6 ≥1048 9 07Programmed track Play sequencePGM/-CLEAR7ACD123