86An example of executing the command to show the RADIUS configuration is shownbelow.Fig. 3-5-4-1 Example of executing the command to show the RADIUS configurationFig. 3-5-4-2 Example of executing the command to show the login method(1) NAS IDShows the authentication ID (NAS Identifier). This parameter is used as a NAS-Identifier(RADIUS attribute 32) in a RADIUS packet (Access-Request) sent by this Switching Hub.(2) IndexShows the authentication order to RADIUS server. The authentication is carried out startingfrom Index No. 1. If the communications with the RADIUS server fails, then the authenticationis carried out for Index No. 2 and so on in ascending order.(3) Server IP addressShows the IP address of RADIUS server.(4) Shared SecretShows the common key (Shared Secret) that is used in authentication. The same key mustbe set between the server side and the client side. In general, system manager set this commonM24eG# show radius-serverNAS ID: Nas1Index Server IP address Shared Secret Response Time Max Retransmission----- ----------------- -------------------- ------------- ------------------1 192.168.1.200 admin 10 Seconds 32 0.0.0.0 10 Seconds 33 0.0.0.0 10 Seconds 34 0.0.0.0 10 Seconds 35 0.0.0.0 10 Seconds 3M24eG#(1)(2)M24eG# show login methodlogin method 1 is Locallogin method 2 is NoneM24eG#(7)(8)(3) (4) (5) (6)
