Panasonic LP-400 Series External Control Manual

Also see for LP-400 Series: Operation and maintenance manual Operation manual

Contents

Panasonic LP-400 Series External Control Manual Manual pdf 28 page image

28⿎ Operation of input signal on I/O terminal blockReference• The ON/OFF listed in this section refers to the ON/OFF operations. It does not refer to the voltage level (High/Low).No. Name/DescriptionA1 +12V OUT: Internal power supply + 12V DC (max. output current 300mA)Use this terminal as the power supply for the I/O signals when operating laser marker without external powersupply.This terminal can be also used as the power supply for external devices such as a sensor or an encoder.Notice• Make sure to use B1 (0V OUT) for the 0V of the internal power A1 (+12V OUT). Do not mix the connecting pattern forusing external and internal power supply.• Do not connect anything to this when using the external power supply for I/O control.• When using the internal power supply (A1, B1), the total current of the power supply for the external device and theconsumption current for the I/O control should be less than 300mA.A2 • For NPN models *1IN COM.: Input commonThe common terminal for each input of the I/O terminal and I/O connector. This A2 and No. 1 of I/O connectorare the common terminals connected internally.For NPN models, this terminal is connected to the “+ (plus)” side of power which is used for control.• For PNP models (“-C” in the end of the model name) *1OUT COM.: Output commonThe common terminal for each output of the I/O terminal and I/O connector. This A2 and No. 1 of I/O connectorare the common terminals connected internally.For PNP models, this terminal is connected to the “+ (plus)” side of power which is used for control.Notice• Do not invert the power wiring of I/O terminal and I/O connector. It may cause a failure. When this terminal is connectedto the power supply, it is not necessary to supply the power to the other IN COM. or OUT COM. on I/O connector.• At the factory shipments, IN COM. and OUT COM. of I/O terminals are connected to the power supply terminals byshort bars respectively. When using the external power supply or connecting to any external devices, remove the shortbars from the terminals to be used.• Short-circuiting IN COM. and OUT COM. in supplying power might cause the short out and also cause the failure withthe laser marker. Be sure to check the wiring before starting the laser marker.Reference• Connect IN COM. and OUT COM. to the power supply respectively.NPN type of laser marker: A2 [IN COM.] ― +V, B2 [OUT COM.] ― GNDPNP type of laser marker: B2 [IN COM.] ― GND, A2 [OUT COM.] ― +V• For the connecting details, refer to “2-3 Connecting I/O Terminal Block” (P.42).A3 REMOTE IN: Remote mode inputWhile this input is turned on, the laser marker operates in the remote mode which can be controlled externallyby I/O and serial communication commands.To transit to the remote mode using this terminal, turn ON the DIP switch No. 5 in advance.Refer to “1-3-3 Shift to remote mode” (P.23).A4 TRIG. IN: Marking trigger inputMarking start signal. This signal can be accepted while READY OUT (B4) is turned ON.Starts marking (laser radiation) by edge of input ON.At equidistant marking to the flying object, marking is performed while this input is ON.ME-LP400V-EX-6