Panasonic KX-TGP600 Quick Setup Manual

Also see for KX-TGP600: Operating instructions Administrator's guide Quick start guide Quick guide Quick start guide

Panasonic KX-TGP600 Quick Setup Manual Manual pdf 2 page image

2PRIMUSBUSINESS.CAPRIMUS BUSINESS SERVICES | HOSTED PBX | PANASONIC TGP600 TPA60 TPA65 QUICK SETUPGUIDESetting Up the Base Unit (KX-TGP600)1. Take the Ethernet cable (included with your unit) and plug one end to theport on the base unit. Plug the other end of the cable to your internetmodem, router, or switch.2. Plug the AC adapter (Part No. PQLV219) into the base unit. Press the plugfirmly to make sure it is in place. There is a hook at the bottom of the unit tosecure the cable in place to prevent it from being accidentally pulled out.Plug the AC adapter into an electrical outlet.3. Once everything is connected, the base unit will go through an auto-configuration process, which may take up to 10 minutes. You are ready tomake and receive calls when the STATUS light indicator turns to solidgreen.NOTE: The configuration may take up to 10 minutes, and may reboot several times.Leave the base unit plugged in for at least 10 minutes before making anychanges. When the base unit is first connected to power, the STATUS indicator willbe solid red. If the STATUS indicator is off, make sure the AC adaptor andEthernet cable are properly plugged in, and verify your network device(modem, router, switch) is on and functioning. If the STATUS indicator remains red or amber after 10 minutes, tryplugging the base unit directly to your Internet modem instead of throughyour routers, switches, or firewalls.