PANASONIC PHONE SYSTEM INSTALLATION GUIDEModel numbers: KX-TGP600, KX-TPA60, KX-TPA65REVIEW ITEMS INCLUDED WITH YOUR PHONE SYSTEMDepending on the equipment ordered, you will have the following items included in your shipment:It is important to note that the initial setup process and registration of your devices can take up to 1 hour. Please ensure that you havecompleted the process to charge your handset (if applicable) prior to beginning the installation process.CONGRATULATIONS ON THE PURCHASE OF YOUR NEW ACN DIGITALTALK® EXPRESS PHONE SYSTEM!Wireless Base Station(KX-TGP600)Ethernet Cable (1)Desktop Phone(KX-TPA65)Screws & Washers forDesktop Wall Mount (2/2)Handset Phone(KX-TPA60)HandsetBatteries (2)AC Adaptor for DesktopPhone (1)DC Output: 6.5 VHandsetBelt Clip (1)AC Adaptor for BaseStation (1)DC Output: 6.5 VDesktopHandset Cord (1)AC Adaptor forHandset Charger (1)DC Output: 5.5 VDesktopHandset (1)DesktopStand (1)Before you begin the installation process, please confirm you have the following:1. An active Internet connection2. All devices associated with your new phone system3. ACN Installation Instructions email (Required for telephone number registration and configuration (see page 2))Once confirmed you have the items noted above, please review then follow the instructions in sequence below, beginning with Step 1.STOPSTEP 1 A – SETTING UP THE HANDSET(S) CHARGER / PREPARING THE HANDSET(S) FOR USE1. Open the battery cover, insert thebatteries and close the cover.2. Connect the AC adaptor to the charger.3. Place handset in charger for at leastsix (6) hours prior to registration/use.Bottom of Handset chargerHandsetSTEP 1 B – ASSEMBLING THE DESKTOP PHONE(S)Bottom of Desktop PhoneDesktop PhoneAttach the AC adaptor, corded handset (and headset, where applicable) to the desktop phone.