6.1 TroubleshootingAppendix 221"PS NO CONNECTED" is displayed. • The power switch is set to OFF.Turn it ON. ( 5.2.1 Before Operating the DECTPortable Station Button Descriptions)• The PS is out of range.Move closer to the CS.• The radio channel is busy or a radio communicationerror occurred.Try again later."REGISTER UNIT" is displayed. • The PS is not registered in the system.Consult your dealer."NO SERVICE" is displayed. • The PS is out of range.Move closer to the CS.You cannot store a phone number andname in the directory.• Your entry exceeds the maximum digits orcharacters.• Do not pause for over 30 seconds whileprogramming.The alarm sounds after pressing theRedial button.• A number is not saved in the Call Log." " flashes or beeps tones soundevery 5 seconds during aconversation.• The battery is low.Charge the batteries fully. ( 5.2.1 Before Operatingthe DECT Portable Station Battery Charge)You charged the batteries fully, but" " flashes.Clean the charge contacts and charge again.It is time to change the batteries. Please purchase newbatteries.The PS stops working duringoperation.Turn the power switch OFF and ON. Then try again.( 5.2.1 Before Operating the DECT Portable StationButton Descriptions)Re-insert the battery and try again. ( 5.2.1 BeforeOperating the DECT Portable Station Battery Charge)Handover does not work. • You moved to a busy CS or are out of range.• You moved while not having a conversation (e.g.,while hearing a busy tone).• The radio channel is busy or a radio communicationerror occurred.The display does not show a strongradio signal " " even though youare near the CS.• Normally, the PS user can make a call even with a" " status. In this case, the current linked CS is stillconnected even though another CS is closer.The alarm sounds during aconversation while receiving a weakradio signal " ."• The radio signal is weak.Move closer to the CS.Problem Remedy
