System Programming 4-81[999] 4.2 System ProgrammingResets all or a specific area of the current assigned data to the default settings. The areas areas follows.All Para : Resets all data to the default settings.System Para: Resets all data to the default settings except for the data of the following 4parameters.CO Para: Resets programs [400] through [403] and [405] through [424] to thedefault settings on an outside (CO) line basis.Ext Para: Resets programs [102], [516] and [600] through [615] to the defaultsettings on an extension basis.DSS Para: Resets the assigned data on the DSS buttons and PF buttons on the DSSconsole.Speed Dial : Resets the System Speed Dialing numbers (00 through 99) assigned inprogram [001].*1 Outside (CO) line number: 1 through 6 / (All outside lines)*2 Extension jack number: 01 through 24 / (All extension jacks)*3 DSS console number: 1 through 2 / (Both DSS console numbers)• This program and [804] “System Data Dump” are not included.• Feature ReferenceSection 3, FeaturesSystem Data Default Set[999] System Data Clear999 NEXT STORESELECT(All/System/CO/Ext/DSS Para/Speed Dial)< To select All, System parameter and/or Speed Dial. >END999 NEXT STORESELECT< To select the CO (outside line) parameter. >ENDoutside line no.*1(1 ··· 6/ )To continueSTORE999 NEXT STORESELECT< To select the Extension parameter. >ENDSTORE999 NEXT STORESELECT< To select the DSS parameter. >ENDSTORE(1···2/ )(01··· 24/ )(All/System/CO/Ext/DSS Para/Speed Dial)(All/System/CO/Ext/DSS Para/Speed Dial)(All/System/CO/Ext/DSS Para/Speed Dial)To continueTo continueTo continue!!extension jack no.*2DSS console no.*3+
