4-60 System Programming[523]-[524] 4.2 System ProgrammingSelects the operation when the length of time programmed in [521] “UCD Busy WaitingTime” expires. Intercept or Disconnect is available.Intercept: The call will be redirected depending on programs [408]-[410] “FlexibleRinging Assignment–Day/Night/Lunch” (Intercept Routing feature). Theextension which receives a redirected call rings during the length of timeprogrammed in [526] “UCD Ringing Time after Intercept”.Disconnect: The call will be disconnected immediately.Default Intercept• This program is effective only when “MODE 3” or “MODE 5” is selected in program [502]“OGM Mode Selection”. If “MODE 4” is selected, the call will be disconnected after theUCD-END outgoing message.• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[523] UCD Busy Mode*125 NEXT3 STORE ENDSELECT(Intercept/Disconnect)!!+Selects the operation when all extensions in the UCD group do not answer an outside callvia the UCD feature within the length of time programmed in [525] “UCD Ringing Timebefore Intercept”. Intercept or Disconnect is available.Intercept: The call is redirected depending on programs [408]-[410] “Flexible RingingAssignment–Day/Night/Lunch” (Intercept Routing – No Answer feature).Disconnect: The call is disconnected.Default Intercept• Feature ReferencesSection 3, FeaturesIntercept Routing, Uniform Call Distribution (UCD)[524] UCD Intercept Mode*125 NEXT4 STORE ENDSELECT(Intercept/Disconnect)+*1: Required only when the optional OGM/FAX DetectionCard is installed.
