Default MODE1• Programs [414]-[416] “Outside (CO) Line Mode – Day/Night/Lunch” are used to assign“DISA1”, “DISA2” or “UCD” to each outside (CO) line according to this assignment.• UCD-END is automatically used when “UCD” is assigned in programs [414]-[416],“Disconnect” is selected in program [523] “UCD Busy Mode”, and “MODE4” is selectedin this program.• DISA is automatically used when “UCD” is assigned in programs [414]-[416], “Intercept”is selected in program [523], and “MODE6” is selected in this program.• If the optional OGM/FAX Detection card is not installed, this assignment should be“MODE1”.• Feature ReferencesSection 3, FeaturesDirect Inward System Access (DISA), Outgoing Message (OGM),Uniform Call Distribution (UCD)4-58 System Programming[502] 4.2 System ProgrammingSelects how the 2 outgoing messages (OGM1 and OGM2) are used, MODE1 throughMODE6.[502] OGM Mode Selection!!05 NEXT2 STORE ENDSELECT(MODE 1/2/3/4/5/6)+Mode123456OGM1DISA1DISA1UCDUCDUCDUCDOGM2DISA1DISA2UCDUCD-ENDDISA1DISADescriptionThe system can receive 2 incoming calls via the DISA featureat the same time. This is useful when receiving many calls.An example: DISA1 is used in the day mode and DISA2 isused in the night mode.The system can hold up to 2 incoming calls via the UCDfeature at the same time until any extension is available.The system disconnects an incoming call via the UCD featurewhen the assigned waiting time in [521] “UCD Busy WaitingTime” expires.An example: UCD is used in the day mode and DISA1 is usedin the night mode.The system leads an incoming call via the UCD feature to theDISA feature by OGM2 when the assigned waiting time in[521] “UCD Busy Waiting Time” expires and “Intercept” isselected in [523] “UCD Busy Mode”.
