4-4 System Programming4.1 Before System ProgrammingAssigns a maximum 6 outside (CO) line groups. Each outside (CO) line must be assigned toan outside (CO) line group. For example, if there are multiple telephone service companiesavailable, outside (CO) lines can be grouped by the company.*1 Outside (CO) line number: 1 through 6 / (All outside lines)* 2 Outside line (TRK) group number: 1 through 6Default Outside (CO) line 1 through 6 – Outside (CO) line group 1 through 6• Each outside (CO) line can only belong to one outside (CO) line group.• Feature ReferenceSection 3, FeaturesOutside CallingProvides the factory default setting. If you change the setting,write the programmed data in the programming table listed insection 7, Programming Tables.[404] Outside (CO) Line Group AssignmentProgram address Program titleAdditional informationProgram sequence:1. Enter program address “404”.2. Press “NEXT”.3. Enter the outside (CO) linenumber (1 through 6) or pressto select all outside (CO) lines.4. Enter the outside (CO) linegroup number (1 through 6).5. Press “STORE”.6. Press “END”.To continue assigning anotheroutside (CO) line number, press“SELECT” instead of “END”and repeat from step 3.You can also continue assigningby pressing “PREV” or“NEXT” instead of “END”.You can go to the previous ornext outside (CO) line andrepeat from step 4.!!Additional Information• When you press , for example in step 3 in program [404], if all outside (CO) lines havebeen assigned as outside (CO) line group 1, “CO : TRK GRP – 1” will be displayed. Ifeach outside (CO) line has been assigned to a different outside (CO) line group,“CO : Mixed” will be displayed.• You can press the SELECT button repeatedly to select the desired parameter, if available.• You can use the or button to move to the next/previous step, if available.(1···6/ )04 NEXT4 END(1···6 )To continueoutside line group no.*2outside line no.*1SELECTProgramdescriptionNEXT PREVorTo continueSTOREProgramming exampleThe following programming instructions assume that you have already entered theprogramming mode.Example: Program [404] “Outside (CO) Line Group Assignment”+
