Features 3-573 Features SSystem Data Default SetThis system can re-initialize the system-programmed data. If all the programmed data iscleared, the system will reset using the default settings by program [999].• The default setting for each programming item is listed in Section 5.1, Default Values.• Required System Programming[999] System Data Clear• Installation Reference2.24 System Data Clear+!!UCD waiting call: Shows for an incoming call via the UCD feature.When the “UCD waiting call” is answered, it becomes a“Received call” and a new record is started.(6) Duration : shows the duration of the call or the UCD call waiting time inHours/Minutes/Seconds.(7) Code: shows the account code appended to the call, account code index number(e.g.: 13), the extension number which uses the Walking COS feature(e.g.: 101) or DISA security code status (e.g.: 0). Code “0” indicates a DISAincoming call without a DISA security code. Codes “1 to 4” indicate a DISAincoming call with DISA security code 01 to 04 respectively. DISA securitycodes are never printed out by SMDR.• This system can store information of up to 64 calls.• This data is not deleted even when the system is reset.• If FLASH is manually sent out during a conversation to make another call withouthanging up, etc., a call record will be printed and a new record started. “F/” will beprinted at the beginning of the dial number on the new record.• When a host PBX code is entered, “=” will be printed between the code and dialednumber.• The language used for an SMDR printout can be selected in program [806].• Connection Reference2.13 Printer and PC Connection• Required System Programming[000] Date and Time Setting[204] Call Duration Count Start Time[800] SMDR RS-232C Communication Parameters[801] SMDR Parameter[802] Incoming/Outgoing Call Selection for Printing[803] Secret Speed Dialing/One-Touch Dialing Printing[804] System Data Dump[805] SMDR Account Code Selection[806] SMDR Language Assignment• Related Feature ReferenceLanguage Selection!!+
