Panasonic FZ-G1 Series Supplementary Instructions Manual

Also see for FZ-G1 Series: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic FZ-G1 Series Supplementary Instructions Manual Manual pdf 2 page image

2Addendum1. The area in which the computer may or may not be taken. This computer is intended for use in Non-Hazardous or Hazard-ous Location classified as EPL Gc, Zone 2 with potential explosiveAtmosphere Gas Groups IIB or IIC*1 only (Refer to IEC 60079-0).Higher classified zones (e.g. Zone 1 or Zone 0) or EPL (e.g. Ga orGb) shall not be entered with this equipment! This computer is specified Temperature class T3 (Refer toEN60079-0). The High Frequency-Power is less than 3.5 W forthe model for Gasgroup IIB and less than 2 W for the model forGasgroup IIC. This computer shall not be used in Underground mining or the like. This computer shall not be used in potential explosive Dust Atmo-sphere of any classification or zone. This computer can be used in areas where non-combustible dustsand nonconductive dusts can be present. The use of this computer is limited. Due to its technical charac-teristics it cannot be used with every possible potential explosive.Check the possible atmospheric conditions against the tempera-ture and the radiation levels emitted by this equipment.2. The sort of connection and components that may ormay not be used and what time. DO NOT connect or disconnect any equipment (any kind of exter-nal or internal device of accessory) unless the area is known tobe Non-Hazardous. (e.g. not at the USB port, card ports or otherconnection points as well as not connected to any kind of dockingstations or other devices while you are inside of Hazardous Loca-tions classified as Zone 2) DO NOT use any equipment (any kind of external or internaldevice of accessory) except for SIM Card while you are inside ofHazardous Locations classified as Zone 2. DO NOT connect or use any kind of power supply (AC adaptor)unless the area is known to be Non-Hazardous. DO NOT connect external Display unless the area is known to beNon-Hazardous. Never REMOVE the battery or insert a battery while in Hazardous Location. If the battery power is running out, leave the classified zone for Charging. DO NOT insert or remove any cards unless the area is known tobe Non-Hazardous.3. The use of the leather case and the avoidance ofelectrostatic charging. Cover this computer with bundled leather case to prevent any pos-sibilities of sparks when this computer has been dropped on a hardsurface in Hazardous area. To avoid electrostatic charging/discharging;- DO NOT rub or abrade on any part of this computer.- DO NOT rub LCD screen with sleeve of your clothes.- DO NOT rub this computer with dry and/or synthetic fibre textile fabric.- This computer is an insulated equipment concerning electrostaticcharging.To avoid the electrostatic charging the person who is carry-ing this computer must wear conductive shoes and conductivegloves (if gloves are necessary).- DO NOT place this computer near an electrostatically chargedobject or an object capable of carrying a static charge.- Cover the surfaces by the specified leather case before use inHazardous area.- DO NOT remove the leather case from this computer when inHazardous area.- DO NOT use this computer with the protective film removed fromthe LCD screen surface or with an unauthorized film applied on theLCD screen surface.- No any kinds of plastic cover shall be used with this computer.- Do not injure the surface coating of LCD and do not remove theLCD protection film.- Do not use in a area with small particles in an air stream, solventvapours, and the like.4. The checking and maintenance of the computer. Substitution of components may impair suitability for Zone 2 withpotential explosive Gas Atmosphere. The user shall not perform repairs or disassemble this computerwhen it is broken. Before taking this computer into a Hazardous area, follow theinspection procedures described below. If some problem is found,DO NOT take this computer into Hazardous area, and send thiscomputer for repair to your dealer or Panasonic Technical Support. The enclosure including display shall be checked for damages. Make sure that there is no damage, crack, wear and tear in all con-nector covers. Make sure that there is no damage, cracks, deformation in otherparts of the computer by physical inspection. Make sure there is no screw which is missing. Make sure that there are no holes or damage in the leather case. Make sure that the caution labels in this computer and leathercase are not peeled off. Turn on this computer and make sure that there is no spark,smoke, smell, strange noise. Make sure that there is no other damage, wear and tear or operation-al malfunctioning compared to when this computer was initially used. Make sure all connector covers shall be closed. Before any use, the display and all the jack and port cover shall bechecked for damages and shall be closed.5. The conditions for use and protection of the computer. This computer is classified as portable equipment. It shall not bepermanently installed in classified Zones. If this computer is dropped, it should be immediately removedfrom the hazardous area, and check the computer for any damagereferring to 4 above. DO NOT place the computer where it can be subjected to shock or vibration. The non-metallic parts of the enclosure shall not be exposed tolong term UV light. The non-metallic parts of this computer shall not be exposed tofrequent temperature changes. The computer must be protected from mechanical impacts. If damages ormalfunction occur, the equipment must be removed from the hazardous area. Do not change the version of BIOS (Model without LAN:V1.00L17M23/Model with LAN: V1.01L17M23). Do not change the version of EC (V1.00L11M23).*1: The Group to which this computer is classified is indicated on thecomputer.EnglishBefore using this computer, read this Addendum and the relevant portions of the computer’s Operating Instructions carefully.ATEX/IECEx InformationFZ-G1B***** (Model without WWAN) FZ-G1C***** (Model with WWAN)TÜV 14 ATEX 7458 XII 3 G Ex ic nA IIC T3 GcIECEx TUR 14.0008XEx ic nA IIC T3 GcTÜV 14 ATEX 7458 XII 3 G Ex ic nA IIB T3 GcIECEx TUR 14.0008XEx ic nA IIB T3 GcWARNING: EXPLOSION HAZARD