Panasonic CY-VHD9500U Operating Instructions Manual

Also see for CY-VHD9500U: Instalation guide Operating instructions Installation instructions

Panasonic CY-VHD9500U Operating Instructions Manual Manual pdf 13 page image

52 CY-VHD9500U CY-VHD9500U 53ENGLISH10The Use of RangePlane view:45e45e Approximately5 m (Max)*Approximately2.5 m (Max)*Approximately2.5 m (Max)*Vertical view:30eApproximately2.5 m (Max)*These headphones use infrared rays for operation.Use them within the range shown in the figure.POWERInfrared receivingportENGLISH9IR Wireless Headphones PreparationBattery Installation(Inserting/Replacing the Batteries)Battery NotesBattery information:≥ Battery type: Manganese R03, AAA, UM-4 drycells (supplied)≥ Battery life: Approximately 18 hours of continuousoperation under normal use (at roomtemperature)Battery life POWER indicatorWhen operation ispossibleLights up green.When the battery needsto be replacedDims or fails to light.To check the remaining battery strength:The POWER indicator on the right hand earpiece (R)dims or fails to light when the batteries are weak.Noise and interference also increase.Change the batteries if any of these occur.POWERPOWERPOWERPOWERPOWER1 Open the battery holdercover.As shown in the fi gure, usethe tool such as a slot-headscrewdriver to disengage thebottom part of the batteryholder cover, and then useyour fi ngers to lift the top partfree.2 Insert the battery.Insert the battery in thecorrect direction, making surethat its positive and negativeends match the same symbolsin the battery holder.3 Replace the cover.The cover is fi xed in placewith a click.POWERPOWER indicator(Right side)(Before wearing headphones)1 Turn the volume on the headphones all the waydown.2 Press the POWER button.≥ The POWER indicator lights up.3 Turn the volume up slowly until you can hearthe sound comfortably and clearly, and withoutdistortion.After UsePress the POWER button to switch off.Note:≥ Refer to “When Listening with IR WirelessHeadphones” (page 10).How to Use the IR Wireless HeadphonesPOWERPOWER buttonVolumeupVolumedownOperations (Power and Volume)Note:≥ One battery is required for the left and another forthe right side of each headphone.Caution:≥ Improper use of the battery may causeoverheating, an explosion or ignition, resultingin injury or a fi re. Battery leakage may damagethe product.≥ Do not expose the IR wireless headphones todirect sunlight.≥ Do not mix old and new batteries.≥ Do not use alkaline dry cells. (There is thedanger of liquid leakage.)≥ Do not recharge, disassemble, deform or heatthe battery.≥ Do not put the battery in fire or water.≥ Immediately replace used up battery.≥ Obey local ordinances when disposing of thebattery.Note:≥ Depending on the vehicle model and amount ofcharge remaining in headphone batteries, theactual range of use may be less than what is givenin the fi gures above.≥ If no infrared signals are received from themain unit for more than one minute after theheadphones power has been turned on, theheadphones power will be automatically turnedoff (auto power function).123* Conditions: The batteries must be fully chargedand in their normal status, room temperaturemust be the temperature, and there must be noobstructions between the main unit and IR wirelessheadphones.