8Read Me FirstRegulatory InformationFor U.S.A.Federal Communications Commission Radio FrequencyInterference StatementNote: This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential instal-lation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordancewith the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interfer-ence will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by oneor more of the following measures:l Reorient or relocate the receiving antenna.l Increase the separation between the equipment and receiver.l Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.l Consult the Panasonic Service Center or an experiencedradio/TV technician for help.WarningTo assure continued compliance, use only shielded interfacecables when connecting to a computer or peripheral. Also, anychanges or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority tooperate this equipment.This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, includinginterference that may cause undesired operation.FCC RF Exposure Warning:l This equipment is provided with PC Card slot that could beused with wireless transmitters, which will be specificallyrecommended when they become available.Other third-party wireless transmitters have not been RFexposure evaluated for use with this computer and may notcomply with FCC RF exposure requirements.l This equipment complies with FCC radiation exposure limitsset forth for an uncontrolled environment.l This equipment has been approved for mobile operation,and unless otherwise advised in separate supplementalinstructions for individual wireless transmitter(s), requiresminimum 20cm spacing be provided between antenna(s)and all person’s body (excluding extremities of hands, wristand feet) during wireless modes of operation.l This equipment may not be co-located or operated with anyother antenna or transmitter.l This equipment is provided with external antennaconnector(s) for connection to optional Car Mounter or PortReplicator for mobile external mounted antenna(s). Exter-nal antenna(s) must be professionally installed and cannotexceed recommended maximum antenna gain as describedin individual provided supplement instructions for wirelesstransmitters.For WLAN, the Car Mounter should be used with Radiall/Larsen WLAN whip antenna, type NMO5E2400BKTNCwith 5dBi antenna gain or less. Also, user must maintainminimum 20 cm spacing between external antenna(s) andall person’s body (excluding extremities of hands, wrist andfeet) during wireless modes of operation.25-M-5This product is restricted to indoor use due to its operation inthe 5.15 to 5.25 GHz frequency range. FCC requires this prod-uct to be used indoors for the frequency range 5.15 to 5.25 GHzto reduce the potential for harmful interference to co-channelMobile Satellite systems. High power radars are allocated asprimary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHzbands. These radar stations can cause interference with and/ordamage this product.25-M-WResponsible Party: Panasonic Corporation of North AmericaTwo Riverfront PlazaNewark, NJ 07102Tel No:1-800-LAPTOP5 (1-800-527-8675)6-M-1FCC Regulation Notice for modemThis equipment contains a FCC approved modem.1. This equipment complies with CFR47 Part 68 rules.On the computer is a label that contains, among other infor-mation, the FCC registration number and ringer equivalencenumber (REN) for this equipment. If required, this informa-tion must be provided to the telephone company.2. An FCC compliant telephone cord and modular plug isprovided with this equipment. This equipment is designed tobe connected to the telephone network or premises wiringusing a compatible modular jack which is Part 68 compliant.See Installation Instructions for details.3. The REN is used to determine the quantity of devices whichmay be connected to the telephone line. Excessive RENson the telephone line may result in the devices not ringing inresponse to an incoming call. In most, but not all area, thesum of RENs should not exceed five (5.0). To be certain ofthe number of devices that may be connected to a line, asdetermined by the total RENs, contact the local telephonecompany.4. If your telephone equipment cause harm to the telephonenetwork, the telephone company will notify you in advice thattemporary discontinuance of service may be required. Butif advice notice isn’t practical, the telephone company willnotify the customer as soon as possible. Also, you will beadvised of your right to file a complaint with the FCC if youbelieve it is necessary.5. The telephone company may take changes in its facilities,equipment, operations or procedures that could affect theoperation of the equipment. If this happens the telephonecompany will provide advance notice in order for you tomake necessary modifications to maintain uninterruptedservice.6. If trouble is experienced with this equipment, for repair orwarranty information, please contact Panasonic Corpora-tion of North America at DIAL TOLL FREE 1-800-LAPTOP5(1-800-527-8675). If the equipment is causing harm to thetelephone network, the telephone company may request thatyou disconnect the equipment until the problem is resolved.7. There are no user serviceable parts contained in this equip-ment.8. This equipment may not be used on coin service providedby the telephone company. Connection to party lines is sub-ject to state tariffs.
