Panasonic BT-PRP17G Operating Instructions Manual

Panasonic BT-PRP17G Operating Instructions Manual Manual pdf 2 page image

2ENGLISHRead this first !Do not attach to monitors installed in high places.The panel may cause injury should it fall off.Only attach to designated monitors.Otherwise this may cause injury or damage to equipment.Do not use at a place subject to vibration.If the protection panel is removed, this may cause bodilyinjury.Before attaching a fastener to a surface, wipe thesurface well to remove any dust or dirt.If dust or dirt remains, the adhesiveness may not bestrong enough, and the panel may fall, causing bodilyinjury or damage.indicates safety instruction.SpecificationsDimensions (W × H × D):423 mm × 263.5 mm × 9 mm(16 3 /4 inches × 10 3/8 inches × 3 /8 inches)Weight: 410 g (0.9 lb)• Protection panel × 1 • Fastener for fitting × 6Fitting procedure1 Affix four fasteners along the lengthof the monitor.Use the four fasteners with bended corner. Foreach fastener, remove its backing and align withthe ridgeline between the monitor and the LCDpanel, and then affix the fastener. Affi x a total offour fasteners, with two on the top and two onthe bottom.Ridgeline2 Affix two fasteners along the width ofthe monitor.Use the remaining two fasteners. For eachfastener, remove its backing and align with theridgeline between the monitor and the LCDpanel, and then affix the fastener. Affi x a total oftwo fasteners, with one on the left and one onthe right.Ridgeline3 Attach the protection panel to themonitor.Place the protection panel with its fastener facingthe monitor. Move the protection panel so that itsupper part is below the tally lamp on the monitor,and then attach the protection panel. Make surethe position is correct, and then firmly press thefour sides of the protection panel.After the installation, check once more to makesure the protection panel is securely attached tothe display.Tally lampCleaningWhen the protection panel is dirty, use a soft clothto wipe it.For stubborn stain, use a cloth dampened with milddetergent diluted with water. Wring the cloth and thenwipe the panel. Finally, wipe with a dry, soft cloth.Do not use thinner or benzene.