Operating Instructions82How toauthenticateYou can select the authentication method: [No authentication],[POP before SMTP authentication] and [SMTP authentication].POP server authentication may be required by your ISP. Inthat case, set POP before SMTP authentication.• No authentication: No authentication when sending an e-mail.• POP before SMTP authentication: Some SMTP serversthat send e-mails do not have an authentication feature.Therefore, the camera uses the authentication of a POPserver that receives e-mails, before sending e-mails.– POP3 ServerIP Address orHost Name*1:If you set a server IP address, set 4numbers (0—255) and 3 periods, such as"192.168.0.253". Note that "0.0.0.0" and"255.255.255.255" are not available. Orset a host name (1—255 characters).– Port No.: Enter a number (1—65535). Usually setto 110.– Login ID*2: If your ISP requires a login ID to log in toa POP3 server, set it (1—63 characters).– Password*2: If your ISP requires a password to log into a POP3 server, set it (0—63characters).• SMTP authentication: Users are authenticated by username and password on the SMTP server. Your ISP mustsupport the SMTP authentication. Only the LOGIN andPLAIN authentication mechanisms are supported.– Login ID*2: If your ISP requires a login ID to log in toan SMTP server, set it (1—63characters).– Password*2: If your ISP requires a password to log into an SMTP server, set it (0—63characters).*1 Note that [Space], ["], ['], [&], [<] and [>] are not available.*2 Note that ["] is not available.Setting Description
