Panasonic AW-RP505 Operating Instructions Manual

Also see for AWRP505 - MULTI HYBRID CTL PAN: Service manual Operating instructions

Contents

Panasonic AW-RP505 Operating Instructions Manual Manual pdf 7 page image

-5-q Power Indicator [POWER]Lights red when POWER ON/OFF Switch w is in theON position, and goes out when the same switch is setto the OFF position.w Power CONTROL Switch [POWER, ON/OFF]All the connected cameras and pan/tilt heads areswitched on when this switch is set to the ON position.(The power indicator lights.) The camera and pan/tilthead are partially switched off when this switch is set tothe OFF position.Note: When the switch is set to the OFF position, thecamera is totally switched off but the communica-tion line between the pan/tilt head and this controlpanel remains live. To disconnect all power sup-ply, pull out the power plug from the electrical out-let.e Operating Indicator [OPERATE]Lights green when communication begins normallybetween the camera and the control panel, and goesout if a communication error occurs.r Camera Control Switch [CAM CONT, ON/OFF]Before making camera settings, select a camera withCONTROL Switch @2 then set CAM CONT Switch r tothe ON position. After making the necessary settings,set CAM CON Switch r back to the OFF position.Note: At the same time as CAM CONT Switch r is setto the ON position, all the switch settings of thiscontrol panel are sent to the selected camera toupdate its settings. Do not shift CAM CONT Switchr to the ON position except when changing thecamera settings. If a different camera is selectedwith CONTROL Switch @2 when CAM CONT Switchr is in the ON position, the settings of the newlyselected camera will also be changed. Beforeselecting another camera with CONTROL Switch@2, be sure to set CAM CONT Switch r back tothe OFF position.t Mode Selection Switch [MODE, BAR/CAM]Used to select camera color bar signals or cameravideo signals. Select a camera with CONTROL Switch@2, set CAM CONT Switch r to the ON position, thenselect the desired type of signal with this switch. Withthe switch set to BAR, the control panel outputs colorbar signals from the video output terminal. When theswitch is set to CAM, it outputs camera video signals.After selecting it, set CAM CONT Switch r back to theOFF position.y AGC Selection Switch [GAIN, AGC/MANU]Keep this switch in the AGC position if you want tokeep automatic gain control. Select a camera withCONTROL Switch @2, set CAM CONT Switch r to theON position, then select AGC or MANU as necessary.When this switch is at AGC GAIN H/M/L switch u isinvalid. After selecting it, set CAM CONT Switch rback to the OFF position.