Panasonic AW-RP505 Operating Instructions Manual

Also see for AWRP505 - MULTI HYBRID CTL PAN: Service manual Operating instructions

Contents

Panasonic AW-RP505 Operating Instructions Manual Manual pdf 14 page image

-12-#7 Focus Lever [FOCUS FAR/NEAR]Used to adjust the focus of the lens that is connectedto the pan/tilt head selected with CONTROL Switch @22.Used to adjust the lens focus at varying speeddepending on the angle of the lever. The lens isfocused far when the lever is moved toward FAR, ornear when the lever is moved toward NEAR, providedthat FOCUS REVERSE Switch %2 is in the NOR posi-tion. When FOCUS REVERSE Switch %2 is set to theREV position, the lens focus operates in the oppositedirection. ZOOM/FOCUS EXCHANGE Switch %1 maybe used to exchange its function with ZOOM Lever #6.#8 Pan/tilt Lever [PAN/TILT, UP/DOWN/LEFT/RIGHT]Used to control the pan/tilt operation of the pan/tilthead selected with CONTROL Switch @22. Controls thehead’s pan/tilt operation at varying speed dependingon the angle of the lever. The pan/tilt head turns upwhen the lever is moved toward UP, or down when it ismoved toward DOWN, provided that TILT REVERSESwitch %3 is in the NOR position. The pan/tilt headmoves in the opposite direction if the TILT REVERSESwitch %3 is in the REV position. The pan/tilt headturns leftward when the lever is moved toward LEFT, orrightward when it is moved toward RIGHT, providedthat PAN REVERSE Switch %4 is in the NOR position.The pan/tilt head moves in the opposite direction if thePAN REVERSE Switch %4 is in the REV position.Note: TILT REVERSE Switch %3 and PAN REVERSESwitch %4 may be used to reverse the operatingdirection of the pan/tilt head, but be sure to set theoperating direction of the pan/tilt head with itsmounting direction selection switch during itsinstallation depending on whether the pan/tilt headis mounted on the floor or is suspended. Unlessthe mounting direction selection switch on thepan/tilt head is properly set, the pan/tilt head willpan or tilt in the opposite direction and the pan/tilthead operation limiters will not be properly storedin the memory. For details on the setting of thisswitch, refer to INSTALLATION OF PAN/TILT HEADat page 19 or the Operating Instructions for thePan/tilt Head.