Panasonic AK-HRP931P Operating Instructions Manual

Contents

Panasonic AK-HRP931P Operating Instructions Manual Manual pdf 5 page image

5Parts and their functionsCamera number indicator [CAMERA NO.]This indicates the camera number information. If the cameranumber is not indicated, “–” appears instead.6Camera video output selector switch[CLOSE/BAR/ TEST]This is used to select the camera video signals which are tobe output from the CCU’s rear panel. The camera videosignal, color bar display signal or test display signal isselected by pressing the BAR switch and/or TEST switch.Both BAR and TEST switch lamps off:Camera video outputBAR switch lamp lighted: Color bar signal outputTEST switch lamp lighted: Test signal outputCLOSE switch lamp lighted: Lens closed status withcamera video output1 Auto white balance switch [AUTO WHITE]This is used to automatically adjust the white balance.Lighted: This indicates that the automatic white balanceadjustment has started.Flashing: This indicates that the automatic white balanceadjustment ended without being completed.Off: This indicates that the automatic white balanceadjustment was completed correctly.78ROP ON switchThis switch enables the controls on the ROP’s operationpanel to be operated. Its lamp lights as soon as the CCUpower is turned on.Lighted: The lamp of the switch lights when the CCU poweris turned on. When communication with thecamera is enabled, the settings at which thepanel's switches are selected are established. Thepanel is set on the basis of the camera settinginformation also immediately after the ROP ONswitch is pressed and its lamp is lighted. However,if it is judged that communication with the camerahas been cut off, the setting at which the panel’sswitches are selected will not be established, andthe ROP ON switch lamp will remain lighted.Off: The lamp turns off and the panel’s operations arecancelled (protected status) when this switch ispressed (while its lamp is lighted) while the CCU’spower and the camera’s power is ON.However, even when the ROP ON switch lamp isoff, the panel’s GAIN, FLARE and DTL controlscan be operated provided that the active indicatoris lighted. It is also possible to operate the irisclose switch irrespective of the ROP ON switchsetting provided that communication with thecamera is enabled.1Camera power switch [HEAD ON]This switch enables the panel to be used to operate thecamera’s power by remote control. However, this functionwill not work unless both the CCU’s camera power switchand the power switch on the camera itself are at the ONposition.Each time the switch is pressed, the status alternatesbetween ON (power ON: LED lighted) and OFF (power OFF:LED off).2Camera power switch indicatorThis indicates whether the camera power is ON or OFF.Lights up green:The panel is communicating with thecamera.Lights up red: The panel is not communicating with thecamera.Flashes red: POWER OFF status established bysoftware.3VF power OFF switch [VF OFF]This is the camera VF power switch for exercising remotecontrol from the panel. It lights when the switch is in the ONposition. Each time the switch is pressed, the statusalternates between ON (power ON) and OFF (power OFF).4SD card slotThis is where the SD cards are inserted. The data of thecamera and CCU can be saved on these cards and thencalled.5ROP ONCLOSE5600K OFFFLAREGAMMA ONBLKOFFGAMMAOFFKNEECLIP OFFWHITEONMATRIXOFFHD. DTLOFFSD. DTLBAR TEST CHARACTER RST OPT FAN60HzCABLEWHITE SET UPBLACKHEAD ON VFPWSD CARDCAMERA NO.ALARMAUTOMODE123 4 8 5 9:67 ;<=ROP operation panelWhen any of the panel switches is pressed, the buzzer sounds.However, the buzzer does not sound when the panel's ONswitch lamp is off or when BUZZ OFF has been selected on theFUNC menu.WHITE SET UPBLACKAUTO1 2 3