OHAUS Navigator NV212 Instruction Manual

Also see for Navigator NV1101: Instruction manual Service manual

Contents

OHAUS Navigator NV212 Instruction Manual Manual pdf 8 page image

EN-6 Navigator®4. SETTINGSThe User Menu allows the customizing of balance settings.Note: Additional Sub-Menus may be available if Interface Options are installed. See Interface UserManual for the additional setting information.4.1 Menu NavigationUser Menu:Sub-Menus: .C.a.l. .S.e.t.u.p. .M.o.d.e. .U.n.i.t. .E.n.d.Menu Items:SpanLinEndA-offDisplyBrightIR.LEFTIR.RGHTEndCountPercntHoldAccumCheckEndct, g, kg, grn,lb, oz, lb:oz,ozt, N, dwt,thk, tsg, ttw,tola, ticalEndPress and hold Menu until [mMeNU] (Menu) is displayed. When released the first sub-menu [.C.a.l.](Cal) will be shown.Press Yes to enter the displayed sub-menu or press No to advance to the next.Selecting a sub-menu will display the first menu item. Press Yes to view the menu item setting orpress No to move to the next menu item. When viewing the setting, press Yes to accept the setting, orpress No to change the setting. When [End] is displayed, press Yes to return to the sub-menuselections or No to return to the first item in the current menu.4.2 Cal Sub-Menu• Span [SpaN] (yes, no) - Initiates a span calibration procedure (zero and span). A spancalibration is important when initially setting up the balance.• Lin [Lin] (yes, no) - Initiates a linearity calibration procedure (zero, mid-point and span).4.3 Setup Sub-MenuThe backlit LCD and (red) LED displays will have different menu items or settings based on thefunctionality.• Auto Off [A-Off] (on, off) - When Auto Off is set to “on” the balance will turn off automaticallyafter 5 minutes of inactivity. Auto off is used to save battery power.• Display [disply] (on, auto, dim (LED), off (LCD)) - This setting controls the LCD backlight orthe LED digits; constant on, automatic turn off after 5 seconds of balance inactivity, dimming ofthe LED after 60 seconds of balance inactivity or LCD backlight always off.• Bright [Bright] (hi, mid, low) - This setting controls the brightness of the LED display. LCDmodels will not see this menu item.• IR Sensor Left [Ir.LEFt] / Right [Ir.rght] (Off, Tare, Function, Print, Zero, Display) - Thesesettings determine the role of the IR Sensors. “Zero”, “Print”, “Function” or “Tare” allows the IRsensor to act the same as the related button. “Display” activates the display if Display-Auto isset. “O• ff” disables the sensor.