Napoleon EPA 1100 Installation And Operation Instructions Manual

Also see for EPA 1100: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions Installation and operating instructions

Contents

mobile home

Napoleon EPA 1100 Installation And Operation Instructions Manual Manual pdf 1 page image

1W415-0512 /C 10.02.06INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212 • fax(705)722-6031www.napoleonfireplaces.com • ask@napoleon.on.caINSTALLATION AND OPERATION INSTRUCTIONS FORHI-TECH LISTED SOLID FUEL BURNING STOVES AND INSERTSFREE STANDING MODELS EPA 1100, 1100L, 1100C, 1150, 1400, 1400L & 1900INSERT MODELS EPI 1101, 1401, 1402CERTIFIED UNDER U.S. ENVIRONMENTAL PROTECTION AGENCY (E.P.A.) JULY 1990 AND THE OREGON DEPARTMENT OF ENVIRONMENTAL QUALITY (D.E.Q.) PAR-TICULATE EMISSION STANDARDS BY E.E.M.C. THESE STOVES HAVE BEEN TESTED AND LISTED BY INTERTEK TESTING SERVICES TO STANDARDS: CSA B366.2 , ULCS627, ULC S628, UL 1482. MODEL 1100 HAS BEEN TESTED AND LISTED FOR INSTALLATION IN MOBILE HOMES.WARNING:Please read this entire manual before you install and use your new room heater. Failure tofollow instructions may result in property damage, bodily injury, or even death.If this unit is not properly installed, a house fire may result.FOR YOUR SAFETYFollow the installation directions. This unit can be very hot when burning. Combustible mate-rials such as firewood, wet clothing, etc. placed too close can catch fire. Adults and especiallychildren should be alerted to the hazards of high surface temperatures and should stay awayto avoid burns or clothing ignition. Keep young children and animals away when the fireplaceis hot. The chimney must be sound and free of cracks. Before installing your unit, contact thelocal building or fire authority and follow their guidelines.The door must be kept closed during operation to prevent smoke, embers from entering theroom. Burn wood directly on firebricks. Do not use a grate or elevate the fire. At least 14 squareinches (90 sq.cm.) of outside air must be admitted to the room or directly to the unit through a4 inch (10cm.) diameter pipe. This unit is designed to burn natural wood only. Higher efficienciesand lower emissions generally result when burning air dried seasoned hardwoods, as com-pared to softwoods or to green or freshly cut hardwoods. Do not start a fire with chemicals orfluids such as gasoline, engine oil, etc. Do not burn treated wood, coal, charcoal, colouredpaper, cardboard, solvents or garbage which tend to produce more pollution than wood. Donot let the unit become hot enough for any part to glow red.KEEP THE STOVE TOP TEMPERATURE BELOW 700°F (371°C). Attempts to achieve heat outputrates that exceed design specifications can result in steel distortion and damage.