NEC NP02LM Installation Manual

Also see for NP02LM Series: Important information

NEC NP02LM Installation Manual Manual pdf 2 page image

2FCC ComplianceThis device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference and (2) this device must accept anyinterference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from thatto which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired operation.FCC Caution: Any changes or modifications not expressly approved by the party responsible forcompliance could void the user's authority to operate this equipment.IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited tochannels 1 through 11.IMPORTANT NOTE:This transmitter must not be co-located or operating in conjunction with any other antennaor transmitter.This equipment complies with FCC RF radiation exposure limits set forth foran uncontrolled environment. This device and its antenna must not beco-located or operating in conjunction with any other antenna ortransmitter.“To comply with FCC RF exposure compliance requirements, this grant isapplicable to only Mobile Configurations. The antennas used for thistransmitter must be installed to provide a separation distance of at least20 cm from all persons and must not be co-located or operating inconjunction with any other antenna or transmitter.”