ENGLISH24DSP Options: 5msTone Controls: Tone Defeat/OnFront Panel Display Setup: Set “Other Sources Front View” to “Source(Simple)”5 With the above settings, scroll to “A/V Presets” from the SETUP MENUpage. Use [S] to access “A/V Presets” menu.6 At “A/V Presets” page, set “Preset: 2” to the following conditions - use[D/F] to select “Yes” or “No” and press [ENTER] to confirm selection andmove to the next setting.While at “Save Current Setup to Preset” menu line, use [S] to save thesettings above to “Preset 2”. When you recall “Preset 2” using the remotecontrol (for HTR 8, “A/V PSET” + “2”), the above preset values allocated at“Preset 2” (preset settings as shown in the OSD captures at Step 4) willbe recalled and effected at the current source.Note that “Speaker Setup” is set to “No”. At this condition, there willbe no “Speaker Setup” values that will be effected at “Preset 2”. The“Speaker Setup” settings that will be applied at “Preset 2” will be the lastor current “Speaker Setup” settings which in this sample are the same“Speaker Setup” settings shown above in Step 1.7 You can setup up to 5 A/V Presets. These same A/V Presets can also beassociated/defaulted to each Source in the “Source Setup” window asbelow.In the above example, “Preset 1” settings are allocated for Source 1.Whenever Source 1 is accessed, the “Preset 1” settings will be appliedto Source 1. You can still manually override the assigned A/V Presetallocation in a specific Source with another Preset setting/number byway of pressing the appropriate remote control buttons.RECALLING PRESETSYou may recall an A/V Preset number at any time using the HTR 8 remotecontrol. Press the HTR 8’s A/V PSET key and then the numeric key 1-5corresponding to the desired A/V Preset number. The newly recalled A/VPreset will then manifest or replace the previous A/V Preset (if any).OPERATIONCONFIGURING T 778 - SETUP MENU VIA ON-SCREEEN DISPLAY