Kingfisher KI 2600 Series Quick Reference Manual

Also see for KI 2600 Series: Operation and maintenance guide Quick reference guide Training manual

Kingfisher KI 2600 Series Quick Reference Manual Manual pdf 2 page image

Quick Reference Guide – KI2600 Series Optical Power Meter EnglishManual operation• To remove interchangeable connector adaptor, press buttonon front of case and pull off adaptor. This may be easier witha test lead attached.• To turn on press [On/Off]• To view firmware version, hold [F4] then press [On/Off].• To view all display segments, press and hold [On/Off], [F1]at the same time until it stops beeping.• To defeat auto power-off, hold [On/Off] for 3 seconds at turnon until ‘Perm’ is displayed.• Low battery is indicated with a battery symbol.• To enter Meter menu, press [Meter]• To enter Memory menu, press [Memory]• To return to Home menu, press [Home]• To save memory to USB stick, in Memory menu, insert stickand press [].• To turn on back light press [ Backlight]Meter Menu:• To select operational wavelength, press [ - ] or [ + ].• To set reference, press [Meter Mode] to enter ‘dB R’, thenpress and hold [SET REF] for 3 seconds. Meter displaysabout 0.00 dB R.• To stop / start display update, press [HOLD].• If a test tone is detected, meter will display ‘Hz.’• To toggle log / linear/relative display mode, press [MeterMode].• To store to memory press [Store]Autotest Operation• To start Autotest press keys below on light source;For light sources with up to 4 : Press [AUTOTEST].For light source with 5 or more :- press [Auto] to start Autotest for the default wavelengthgroup (possibly “singlemode”).- hold [-] then press [Auto] to initiate Autotest for the otherwavelength group (possibly “multimode”).• To stop / start display update, press [HOLD].• To toggle logarithmic / linear / relative display mode, press[Meter Mode]. Measured optical power will be displayed in‘dBm’, ’μW’ or ‘dB R’.• To view the nominal source power, press [Meter Mode] toenter ‘dBm’ or ’μW’, then press [+].• To set reference, press [Meter Mode] to enter ‘dB R’ thenpress and hold [Set Ref] for 3 seconds.• To view reference value, press [Meter Mode] to enter ‘dBR’, then press [+].Memory Operation• To record data to internal memory in Meter or Autotestmodes, press []. Data will be stored in the next location.Memory menu