512 Keysight N9927-90001 User’s GuideFile ManagementSaving and Recalling Files— SD Card Saves/Recalls/Moves (Copies) files to/from the SD card (notincluded), inserted in the card slot. See “Take the FieldFox Tour” onpage 33. Only the root folder is available.— USB Saves/Recalls/Moves (Copies) files to or from a USB Flash drive(not included) that is inserted in one of the USB connectors. Only theroot folder is available.How to set File Type— Press Save/Recall 9— Then File Type. Choose one of the following:— State Saves ALL FieldFox instrument settings for ALL Modes to a*.sta file. If a calibration is ON in CAT or NA Mode, calibration data isalso saved. This file can be opened ONLY by a FieldFox. State filescan be saved between compatible FieldFox models. See notein.“Saving and Recalling Files” on page 506.— Trace+State Saves the current trace and instrument settings to a*.sta file. In SA Mode, all traces are saved. This file can be openedONLY by a FieldFox. When recalled, the FieldFox sweep is set to Hold.— Picture (PNG) Saves a 640 x 453 pixel image of the FieldFox screen toa *.png file. The picture does NOT include the softkeys.— Data (csv) Saves trace data from the current Mode to a *.csv file. Thisformat can be imported into spreadsheet software such as MicrosoftExcel. Column A is always the frequency at which the data ismeasured.——In SA Mode, all visible data traces are saved. Each trace issaved to a separate column that is labeled with the TraceState.——In CAT and NA Modes, only the data trace is saved – not thememory trace.——In Power Meter (with Option 208 Frequency Offset PowerSensor (FOPS)), all visible traces are saved. Each trace is savedto a separate column labeled Output Power or Memory.——In VVM Mode, NO data is saved.Insert only ONE USB Flash Drive in the FieldFox when saving or copyingfiles.When using RTSA, the Density Spectrum information is not saved usingTrace+State. Only the last displayed trace settings is saved.
