Menu
Kestrel KT-50 Manual
    |
IMPORTANT SAFETY INSTRUCTIONSCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVETHE POWER SUPPLY UNIT COVER. THERE ARE NO USER SERVICEABLEPARTS INSIDE. REFER ALL SERVICING TO QUALIFIED PERSONNEL.Please read this manual carefully and keep it in a safe place for future reference.• This appliance is a low voltage AC device.• No naked flame sources such as lighted candles should beplaced on this apparatus, failure to observe this could cause arisk of fire.• Do not place a liquid containing vessel, such as a vase on thisapparatus, as this can result in a risk of fire or electric shock.• Do not expose this apparatus to rain or place it where it maycome into contact with splashing or dripping water.• If this apparatus accidentally gets wet, unplug it and contact anan authorised dealer, service agent or re-seller.• You can clean this apparatus with a damp cloth whennecessary, but be sure to isolate and unplug the apparatus first.• To cut off the power source totally, unplug the apparatus fromthe wall outlet.• Do not overload wall outlets, extension cords or adaptorsbeyond their capacity, since this can result in fire or electric.shock.• Use only the supplied AC power adaptor for the country of use,should they need replacement please consult your dealer or supplier.• Be sure to hold the plug, not the cord, when disconnecting thisapparatus from an electric socket.• Power supply cords should be routed so that they are not likelyto be walked on or pinched by items placed upon or againstthem, paying particular attention to cords at the plug end,adaptors and the point they exit from the appliance.• Before connecting the AC power cord to the Power supply unit,make sure the voltage of the Power supply unit, as marked onthe label on the bottom, corresponds to the local electricity supply.• If this apparatus does not operate normally in particular, if thereare any unusual sounds or smells, unplug it immediately andconsult an authorised dealer, service agent or re-seller.• Unplug this apparatus from the AC outlet before attempting any service work.• Only a qualified technician should remove the Power supply unit cover.TABLE OF CONTENTS1. Safety Instructions2. Un-packing instructions/Cleaning3 - 4. Setup & Connections5. Adjustments6. Operation7. GuaranteeRCA SOCKETSRED = RIGHTWHITE = LEFTGROUNDCONNECTORTERMINALPOWER SUPPLYSOCKET ANDON/OFF BUTTONMOTOR PULLEYTOP GROOVE= 33 1/3 RPMBOTTOM GROOVE= 45 RPMVERTICALTONEARMADJUSTMENTCOLLAR (VTA)PLATTER ANDSUB PLATTERLIFTLOWERDEVICEANTI-SKATEBIAS ASSEMBLYCOUNTER WEIGHTAND REAR STUBCARTRIDGE ONHEADSHELLPLEASE NOTE THAT THE BELOW DIAGRAM APPLIES TO ALL MODELSEXAMPLE SHOWN IS A MODEL KT-200PLINTHTONEARM |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved